TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] UART Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page UART Protection Highlights: Lower speed serial data transfer interface Operating lines: GND, ±TX, ±RX Datalines (±Tx, ±Rx) Operating voltage: 3.3V, recommended Vbr > 3.6V Data rates up to 5Mbps TI…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] RS232 and RS485 Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page RS232 and RS485 Protection Highlights: RS-485 – Industry standard protocol for data transfer from sensors, etc. Drive capability of minimum 32 unit loads (UL, 12kΩ) Uses two signal lines A & B which must be balanced…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    Unused inputs and Outputs on SN65LBC174A-EP and SN65LBC173 0 Locked

    1891 views
    7 replies
    Latest over 13 years ago
    by Thomas Kugelstadt
  • Not Answered

    PCIe external reference clock (100 MHz) 0 Locked

    1408 views
    6 replies
    Latest over 13 years ago
    by Marko Marin
  • Answered

    TPL0102 I2C read 0 Locked

    2101 views
    2 replies
    Latest over 13 years ago
    by Bill Largen
  • Not Answered

    I2C example 0 Locked

    353 views
    2 replies
    Latest over 13 years ago
    by Elias Villegas M.
  • Not Answered

    SN75LVDT1422 LVTTL Jitter 0 Locked

    286 views
    1 reply
    Latest over 14 years ago
    by Miguel Robertson
  • Not Answered

    TUSB9261 FW writing issue and SATA device not recognized 0 Locked

    834 views
    6 replies
    Latest over 14 years ago
    by Chen Zhao84382
  • Answered

    output waveform of HVD232 and HVD230 0 Locked

    1364 views
    2 replies
    Latest over 14 years ago
    by John11513
  • Answered

    Request BSDL file TLK1201AIRCP 0 Locked

    357 views
    2 replies
    Latest over 14 years ago
    by lam fong
  • Not Answered

    LVDS scaling 0 Locked

    493 views
    1 reply
    Latest over 14 years ago
    by RE
  • Not Answered

    USB 3.0 USB Attached SCSI-UAS protocol storage device driver 0 Locked

    6489 views
    12 replies
    Latest over 14 years ago
    by Brian Quach
  • Answered

    TUSB73x0 unused superspeed interface 0 Locked

    273 views
    1 reply
    Latest over 14 years ago
    by Elias Villegas M.
  • Discussion

    Protection 5KV for Profibus ISO1176 Locked

    1435 views
    2 replies
    Latest over 14 years ago
    by Thomas Kugelstadt
  • Answered

    LVDS Switchable Mapping Device 0 Locked

    334 views
    5 replies
    Latest over 14 years ago
    by RE
  • Answered

    TIUSB3 0 Locked

    480 views
    4 replies
    Latest over 14 years ago
    by Aqeel Ahmad
  • Not Answered

    TUSB2136 USB Keyboard Controller 0 Locked

    322 views
    1 reply
    Latest over 14 years ago
    by Elias Villegas M.
  • Not Answered

    TUSB3210 Self Power 0 Locked

    351 views
    4 replies
    Latest over 14 years ago
    by Elias Villegas M.
  • Answered

    TUSB7320/TUSB7340 debug capability 0 Locked

    579 views
    3 replies
    Latest over 14 years ago
    by DHarmon
  • Not Answered

    TUSB6250 firmware source 0 Locked

    527 views
    3 replies
    Latest over 14 years ago
    by DHarmon
  • Answered

    TUSB3410 - Mac OS X 0 Locked

    1207 views
    8 replies
    Latest over 14 years ago
    by DHarmon
  • Not Answered

    PCIe Connection to 3 DSPs 0 Locked

    265 views
    3 replies
    Latest over 14 years ago
    by DHarmon
<>