TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS110DF111: How common 10G ethernet specifications fit into a typical application

    Lucas Wolter
    Lucas Wolter
    Part Number: DS110DF111 In this FAQ, I will explain how common 10G ethernet specifications fit into a typical application. The below application diagram comes from the DS110DF111 datasheet. Many 10G ethernet specifications are defined by the IEEE…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83869HM: Bridge Mode Clarification

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83869HM The DP83869HM supports two types of Bridge Modes to translate data between two MAC interface types. The two types are: RGMII-to-SGMII mode SGMII-to-RGMII mode The naming convention implies MAC-to-PHY and the functionality…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    SN65DPHY440SS: Using for MIPI 8lane of Camera Image Sensor 0 Locked

    832 views
    4 replies
    Latest over 4 years ago
    by David (ASIC) Liu
  • Suggested Answer

    TUSB8020B-Q1: When linux start finish. There are too many dmesg with usb port which hub attached. 0 Locked

    811 views
    5 replies
    Latest over 4 years ago
    by Malik Barton57
  • Answered

    Product recommendation inquiry 0 Locked

    248 views
    4 replies
    Latest over 4 years ago
    by Malik Barton57
  • Answered

    SN75DP139: DP++ to DP and HDMI conversion 0 Locked

    894 views
    10 replies
    Latest over 4 years ago
    by David (ASIC) Liu
  • Suggested Answer

    SN75DP159: Schematics Review 0 Locked

    341 views
    5 replies
    Latest over 4 years ago
    by David (ASIC) Liu
  • Suggested Answer

    MAX232: data rate when C1 = C2 = 0.085uF 0 Locked

    370 views
    4 replies
    Latest over 4 years ago
    by Clemens Ladisch
  • Suggested Answer

    DS90UB934-Q1: MAP results 0 Locked

    315 views
    7 replies
    Latest over 4 years ago
    by Hamzeh Jaradat
  • Suggested Answer

    DS90UB947-Q1: Two serializers connected to the same LVDS input? 0 Locked

    362 views
    11 replies
    Latest over 4 years ago
    by Hamzeh Jaradat
  • Answered

    TPS65987DDK: PD - Ending up in Hard_Reset message negotiating DisplayPort Alt Mode 0 Locked

    416 views
    1 reply
    Latest over 4 years ago
    by Christian Duenki
  • Answered

    TPS25750: Can we use TPS25750+BQ25730 for an integrated battery charging? 0 Locked

    890 views
    4 replies
    Latest over 4 years ago
    by TONG TONG
  • Not Answered

    TL16C2552: difference of interrupt behavior between TL16C2552 and PC16552 0 Locked

    321 views
    3 replies
    Latest over 4 years ago
    by BOBBY
  • Answered

    DP83826E: Link loss after successful autonegotiation completed +1 Locked

    534 views
    9 replies
    Latest over 4 years ago
    by Andrea Tessadri
  • Answered

    Do TI have any solution to evaluate 40GBASE-KR4? 0 Locked

    276 views
    3 replies
    Latest over 4 years ago
    by Kallikuppa Sreenivasa
  • Suggested Answer

    TMUXHS4212: Mux/Demux Switch for PCIe Gen2.0 Data and Reference Clock 0 Locked

    879 views
    3 replies
    Latest over 4 years ago
    by Brian Zhou
  • Answered

    TPS25750: GPIO as plug in detections 0 Locked

    146 views
    2 replies
    Latest over 4 years ago
    by Jim Tseng
  • Suggested Answer

    Link cannot be established once the fiber cable is disconnected and connected again 0 Locked

    319 views
    3 replies
    Latest over 4 years ago
    by Kallikuppa Sreenivasa
  • Answered

    TCAN1144-Q1: Question of TCAN1145-Q1 0 Locked

    456 views
    7 replies
    Latest over 4 years ago
    by Jimmy Lai
  • Suggested Answer

    DP83TG720R-Q1: change from RJ45 Gigalane to the 1000Base-T 0 Locked

    286 views
    3 replies
    Latest over 4 years ago
    by Kallikuppa Sreenivasa
  • Suggested Answer

    TCA9555:I2C rise/fall time requirement 0 Locked

    770 views
    2 replies
    Latest over 4 years ago
    by BOBBY
  • Answered

    DP83TD510E: design spec or notes for DP83TD510E 0 Locked

    318 views
    3 replies
    Latest over 4 years ago
    by Kallikuppa Sreenivasa
<>