TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DP83TC812S-Q1: How to to adjust slew rate of MAC IOs

    David Creger
    David Creger
    Part Number: DP83TC812S-Q1 Reducing the slew rate of MAC interface IOs can provide improvement in EMC emissions for some frequencies. This can be done using register 0x456. 0x456 bits [5] and [0] control the impedance of the RX and TX MAC interface…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Announcing New GUI Application for Ethernet EVM & PHY Evaluation

    Evan Mayhew
    Evan Mayhew
    All, Excited to share the initial release of DIEP (Debug Interface for Ethernet PHYs). The Windows GUI is designed to simplify the process for PHY-level configuration and debug with register access. Using a valid USB connection to an on-board MSP…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] SN65DSI84: Swapping between DSI 83/84/85

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: SN65DSI84 Other Parts Discussed in Thread: SN65DSI83 , , SN65DSI85 Swapping DSI 83/84/85 FAQ Before we begin here is a brief overview of each part and its capabilities: SN65DSI83: SINGLE channel MIPI DSI to SINGLE channel LVDS Bridge…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TDP1204: What is the difference between the TDP1204 and the TMDS1204 HDMI 2.1 redrivers?

    Zach Dryer
    Zach Dryer
    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 When choosing to design in either TDP1204 and TMDS1204, the system designer should consider the differences between the two HDMI 2.1 redrivers. This thread highlights the differences and provides…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83869HM: SGMII Output Differential Voltage Clarification

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83869HM The SGMII Output spec is slightly ambiguous, the purpose of this FAQ is to clear up the terminology. Our data sheet has the following spec: SGMII OUTPUT Min Typ Max Unit Output Differential Voltage …
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to Confirm Ethernet PHY Strapping

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Other Parts Discussed in Thread: DP83869 Our Ethernet PHYs have Hardware Bootstraps that allow the PHY to be configured without the need for register access and also set the PHY ID. Either one of these being mismatched can cause issues, e.g. PHY is configured…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83826I: How do I debug a PHY issue within an EtherCAT network?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826I 3644.How to debug PHY level issues in EtherCAT networks.pdf
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] 10base-T and 10 base-Te difference

    Hillman Lin
    Hillman Lin
    What is the difference between 10Base-T and 10Base-Te?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E-EVM: How to use ping and iperf between two PCs through 510EVM Link?

    Evan Mayhew
    Evan Mayhew
    Part Number: DP83TD510E-EVM ping&iperf_510.ppt
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: How does pin 29 on DP83826 act depending on strap mode?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E DP83826 in Enhanced mode has a pin which is GPIO, pin 29. This pin can be an LED or can be used as CRS. When PHY is set in RMII mode, this pin can be reprogrammed to be LED or CRS. When MII is strapped, this pin is forced to be CRS…
    • over 2 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    DP83TD510E: LED_2 polarity 0 Locked

    80 views
    1 reply
    Latest 6 months ago
    by Vivaan Jaiswal
  • Answered

    DS560MB410: Interface forum 0 Locked

    167 views
    3 replies
    Latest 6 months ago
    by Drew Miller1
  • Suggested Answer

    TVS2200: How many GND via holes is sufficient for the surge energy IEC 61000-4-5 (8/20 µs): 40 A 0 Locked

    419 views
    5 replies
    Latest 6 months ago
    by McKenzie Eaker
  • Suggested Answer

    TCAN1043-Q1: nfault pin internal structure and pull low behavior analysis 0 Locked

    142 views
    3 replies
    Latest 6 months ago
    by Ethan Sempsrott
  • Answered

    SN75DP159: Inter-pair skew issue 0 Locked

    395 views
    13 replies
    Latest 6 months ago
    by David (ASIC) Liu
  • Suggested Answer

    DP83869HM: DP83869HM not initiating any auto negatition pulse and dont see any lights glowing on RJ45 also 0 Locked

    587 views
    18 replies
    Latest 6 months ago
    by David (ASIC) Liu
  • Suggested Answer

    DP83869HM: DP83869 Phy HW address is not detecting 0 Locked

    220 views
    4 replies
    Latest 6 months ago
    by David (ASIC) Liu
  • Answered

    DP83867IS: Preamble Suppression Capable 0 Locked

    194 views
    4 replies
    Latest 6 months ago
    by David (ASIC) Liu
  • Suggested Answer

    DS42BR400: Temperature and communication problem 0 Locked

    206 views
    6 replies
    Latest 6 months ago
    by David (ASIC) Liu
  • Suggested Answer

    DP83822HF: Register operation problem 0 Locked

    102 views
    2 replies
    Latest 6 months ago
    by David (ASIC) Liu
  • Suggested Answer

    SN65DSI83: SN65DSI83 0 Locked

    188 views
    4 replies
    Latest 6 months ago
    by David (ASIC) Liu
  • Answered

    DS90UB983-Q1: is there any possible to separate the harness to two connector ? 0 Locked

    183 views
    5 replies
    Latest 6 months ago
    by Jack Scherlag
  • Suggested Answer

    SN75179B: Datasheet typo? SLLS003E vs SLLS003F 0 Locked

    148 views
    3 replies
    Latest 6 months ago
    by Parker Dodson
  • Suggested Answer

    DP83867IR: RGMII Control Register (RGMIICTL) Address 0x0032, clarification on wording 0 Locked

    226 views
    1 reply
    Latest 6 months ago
    by David (ASIC) Liu
  • Answered

    DP83848K: Application Note of Ethernet Compliance Testing 0 Locked

    211 views
    3 replies
    Latest 6 months ago
    by J
  • Suggested Answer

    DS90UB913A-Q1: Pair with 954 EVM 0 Locked

    142 views
    3 replies
    Latest 6 months ago
    by Zoe Bison
  • Suggested Answer

    SN65HVD251-Q1: Models available for simulation 0 Locked

    224 views
    6 replies
    Latest 6 months ago
    by Ethan Sempsrott
  • Suggested Answer

    DS90UB941AS-Q1: compatibility 0 Locked

    140 views
    1 reply
    Latest 6 months ago
    by Hamzeh Jaradat
  • Suggested Answer

    DS90UB948-Q1: DS90UB948 AC Capacitor 0 Locked

    137 views
    1 reply
    Latest 6 months ago
    by Hamzeh Jaradat
  • Suggested Answer

    DS160PR410: SIGCON for DS160PR410 0 Locked

    105 views
    1 reply
    Latest 6 months ago
    by David Waier
<>