TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS110DF111: How common 10G ethernet specifications fit into a typical application

    Lucas Wolter
    Lucas Wolter
    Part Number: DS110DF111 In this FAQ, I will explain how common 10G ethernet specifications fit into a typical application. The below application diagram comes from the DS110DF111 datasheet. Many 10G ethernet specifications are defined by the IEEE…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83869HM: Bridge Mode Clarification

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83869HM The DP83869HM supports two types of Bridge Modes to translate data between two MAC interface types. The two types are: RGMII-to-SGMII mode SGMII-to-RGMII mode The naming convention implies MAC-to-PHY and the functionality…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    Looking for MDC/MDIO buffer ? 0 Locked

    689 views
    1 reply
    Latest over 9 years ago
    by Ross Pimentel
  • Suggested Answer

    XIO2213BEVM materials (WT technology korea) 0 Locked

    1224 views
    7 replies
    Latest over 9 years ago
    by Elias Villegas M.
  • Answered

    TUSB4041I Vih/Vil of XI pin 0 Locked

    577 views
    1 reply
    Latest over 9 years ago
    by Elias Villegas M.
  • Answered

    DS125DF1610 with 4 TLK10232 function block check 0 Locked

    917 views
    3 replies
    Latest over 9 years ago
    by Luis Omar Moran
  • Not Answered

    May we know how to test DS90ub913/914 performance? 0 Locked

    358 views
    0 replies
    Started over 9 years ago
    by Chen Bogey8
  • Not Answered

    TPS65983 config tool version 2.7 setting issue on INTEL Alpine Ridge 0 Locked

    1738 views
    3 replies
    Latest over 9 years ago
    by Arun Menon
  • Answered

    The pps of Dp83640 disappear when there is a large negative change. 0 Locked

    874 views
    5 replies
    Latest over 9 years ago
    by Rob Rodrigues
  • Answered

    When dp83640 use in fiber mode, does it support synchronous ethernet? 0 Locked

    635 views
    1 reply
    Latest over 9 years ago
    by Rob Rodrigues
  • Not Answered

    DS125DF1610 with 4 TLK10232 function block check 0 Locked

    482 views
    2 replies
    Latest over 9 years ago
    by Jacky Chen29
  • Suggested Answer

    DS90UB914A-Q1:Parity Error Count 0 Locked

    582 views
    2 replies
    Latest over 9 years ago
    by Masaaki Sugiyama
  • Answered

    TRS3243E support EIA423??? 0 Locked

    1317 views
    5 replies
    Latest over 9 years ago
    by Ron Michallick
  • Suggested Answer

    DP83910A operation at slower speeds 0 Locked

    568 views
    1 reply
    Latest over 9 years ago
    by Rob Rodrigues
  • Answered

    TUSB8040A versus TUSB8040A1 0 Locked

    645 views
    2 replies
    Latest over 9 years ago
    by David Blevins
  • Not Answered

    Question about re-new obsolete 139 front end 0 Locked

    532 views
    1 reply
    Latest over 9 years ago
    by Elias Villegas M.
  • Suggested Answer

    Question about TLK10022 serial link aggregator 0 Locked

    643 views
    1 reply
    Latest over 9 years ago
    by Luis Omar Moran
  • Not Answered

    How to choose right parts to replace Bourns device? 0 Locked

    683 views
    1 reply
    Latest over 9 years ago
    by Alec Forbes
  • Not Answered

    Asking for the latest type C ESD short protection device 0 Locked

    509 views
    1 reply
    Latest over 9 years ago
    by Alec Forbes
  • Not Answered

    FIT data for ISO1050DWR 0 Locked

    228 views
    0 replies
    Started over 9 years ago
    by rockne ardoyno
  • Not Answered

    TCA5013EVM performing I/O on the smart card interfaces 0 Locked

    812 views
    2 replies
    Latest over 9 years ago
    by Till Busse
  • Answered

    SN65HVD11DR Conditions of use environment 0 Locked

    742 views
    3 replies
    Latest over 9 years ago
    by Seishin
<>