TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] UART Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page UART Protection Highlights: Lower speed serial data transfer interface Operating lines: GND, ±TX, ±RX Datalines (±Tx, ±Rx) Operating voltage: 3.3V, recommended Vbr > 3.6V Data rates up to 5Mbps TI…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] RS232 and RS485 Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page RS232 and RS485 Protection Highlights: RS-485 – Industry standard protocol for data transfer from sensors, etc. Drive capability of minimum 32 unit loads (UL, 12kΩ) Uses two signal lines A & B which must be balanced…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    Generating Frame Sync signals from 3G/HD/SD SDI video input 0 Locked

    1154 views
    3 replies
    Latest over 10 years ago
    by Nikoo Naeemi
  • Answered

    [ DS90UB928 ] Delay from RIN to Valid Back Channel Communication 0 Locked

    495 views
    2 replies
    Latest over 10 years ago
    by Jason Blackman
  • Not Answered

    DS80PCI402 in a dual PCIe x2 configuration 0 Locked

    376 views
    1 reply
    Latest over 10 years ago
    by Michael Lu (Santa Clara)
  • Not Answered

    Can you recommend some devices for me,thank you. 0 Locked

    1347 views
    12 replies
    Latest over 10 years ago
    by Michael J Schultis
  • Answered

    About skew time of ISO7640FM 0 Locked

    481 views
    2 replies
    Latest over 10 years ago
    by SaranganValavan
  • Not Answered

    TS3USB31 : PCB LAYOUT 0 Locked

    378 views
    1 reply
    Latest over 10 years ago
    by Diego Cortes
  • Not Answered

    TFP410 output not recognized by some devices 0 Locked

    545 views
    1 reply
    Latest over 10 years ago
    by Robert Sefton
  • Not Answered

    TCA8418 keypad controller with i.MX6 processor 0 Locked

    2569 views
    3 replies
    Latest over 10 years ago
    by Brian Berner
  • Not Answered

    Pass and Lock Level of DS90UB914A-Q1 on BCI Test 0 Locked

    768 views
    2 replies
    Latest over 10 years ago
    by Jeffrey
  • Answered

    Inquiry regarding datasheet characteristics on AM26C32 0 Locked

    1018 views
    6 replies
    Latest over 10 years ago
    by Ron Michallick
  • Not Answered

    LMH0387 Extended 3G reach mode mechanism 0 Locked

    629 views
    3 replies
    Latest over 10 years ago
    by Nasser Mohammadi
  • Not Answered

    DP83848C 0 Locked

    1978 views
    17 replies
    Latest over 10 years ago
    by Ross Pimentel
  • Answered

    About performance information of TUSB9261 0 Locked

    527 views
    5 replies
    Latest over 10 years ago
    by Diego Cortes
  • Not Answered

    Bist Mode between ds90uh925 and ds90uh928 0 Locked

    416 views
    0 replies
    Started over 10 years ago
    by user4172310
  • Not Answered

    DP83865DVH PHY problem on 2 of 4 boards. 0 Locked

    824 views
    7 replies
    Latest over 10 years ago
    by Mark Green
  • Answered

    XIO2001 behavior 0 Locked

    1792 views
    16 replies
    Latest over 10 years ago
    by g.f.
  • Not Answered

    DP83640/DP83630 configuration with kernel device tree 0 Locked

    1644 views
    3 replies
    Latest over 10 years ago
    by Kevin Cheng72
  • Answered

    DS25CP104A/114 - Input capacitance of SCL, SDA pins 0 Locked

    567 views
    2 replies
    Latest over 10 years ago
    by Kawai
  • Not Answered

    DS80PCI402SQ, and DS80PCI800SQE ibis model request. 0 Locked

    360 views
    1 reply
    Latest over 10 years ago
    by Michael Lu (Santa Clara)
  • Not Answered

    TUSB1210 used with LPC4330.. 0 Locked

    422 views
    1 reply
    Latest over 10 years ago
    by Diego Cortes
<>