TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS110DF111: How common 10G ethernet specifications fit into a typical application

    Lucas Wolter
    Lucas Wolter
    Part Number: DS110DF111 In this FAQ, I will explain how common 10G ethernet specifications fit into a typical application. The below application diagram comes from the DS110DF111 datasheet. Many 10G ethernet specifications are defined by the IEEE…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83869HM: Bridge Mode Clarification

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83869HM The DP83869HM supports two types of Bridge Modes to translate data between two MAC interface types. The two types are: RGMII-to-SGMII mode SGMII-to-RGMII mode The naming convention implies MAC-to-PHY and the functionality…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TUSB320: 怎么设置USB端口的输出电流在100mA附近? 0 Locked

    947 views
    1 reply
    Latest over 1 year ago
    by David (ASIC) Liu
  • Suggested Answer

    TCA8424: preprogrammed or not sold in digikey 0 Locked

    220 views
    2 replies
    Latest over 1 year ago
    by Tyler Townsend
  • Suggested Answer

    TUSB4041I: Port 1 always shows "port1: over-current condition" 0 Locked

    532 views
    10 replies
    Latest over 1 year ago
    by Brian Zhou
  • Answered

    TUSB4020BI: Schematic review 0 Locked

    437 views
    5 replies
    Latest over 1 year ago
    by Brian Zhou
  • Answered

    SN65C1167E: Alternative to SN65C1167E for higher ambient temperature 0 Locked

    356 views
    3 replies
    Latest over 1 year ago
    by Clemens Ladisch
  • Answered

    DP83869HM: Unmanaged 1000M Media Converter Application 0 Locked

    773 views
    20 replies
    Latest over 1 year ago
    by Lars
  • Answered

    TCAN1145-Q1: Schematic and Layout Review request for HKMC CCIC POIP Headunit 0 Locked

    331 views
    4 replies
    Latest over 1 year ago
    by Kenneth Lee
  • Answered

    DS80PCI102: Please help to review the schematic 0 Locked

    450 views
    10 replies
    Latest over 1 year ago
    by Lisa Xu
  • Suggested Answer

    TL16C754B: TL16C754B related issues 0 Locked

    217 views
    1 reply
    Latest over 1 year ago
    by BOBBY
  • Suggested Answer

    UCC28C45: Different batch of ucc28c45 under different output current conditions, the output voltage will drop 0 Locked

    470 views
    10 replies
    Latest over 1 year ago
    by Hong Huang
  • Suggested Answer

    ONET1151L: ADN25 0 Locked

    218 views
    1 reply
    Latest over 1 year ago
    by David (ASIC) Liu
  • Answered

    DS160PT801: DS160PT801 for PCIE bifurcation 0 Locked

    428 views
    6 replies
    Latest over 1 year ago
    by Nasser Mohammadi
  • Not Answered

    DP83TG720S-Q1: SMI 0 Locked

    386 views
    13 replies
    Latest over 1 year ago
    by Avtar Dhaliwal
  • Suggested Answer

    DP83TC811SEVM: DP83TC811SEVM 0 Locked

    315 views
    1 reply
    Latest over 1 year ago
    by David Creger
  • Suggested Answer

    DP83826E: Ethernet PHY In Passthrough 0 Locked

    367 views
    3 replies
    Latest over 1 year ago
    by Gerome Cacho
  • Answered

    SN65DP159: qualification testing - importance of testing the entire supply voltage range 0 Locked

    347 views
    4 replies
    Latest over 1 year ago
    by Vishesh Pithadiya
  • Not Answered

    SN65DSI84: Test Pattern 0 Locked

    535 views
    11 replies
    Latest over 1 year ago
    by Vishesh Pithadiya
  • Suggested Answer

    TCAN1042-Q1: TCAN1042-Q1 0 Locked

    321 views
    1 reply
    Latest over 1 year ago
    by Sean Guo
  • Answered

    TUSB320: Junction Temp 0 Locked

    257 views
    2 replies
    Latest over 1 year ago
    by Shane Hauser
  • Suggested Answer

    DS160PR810: [DELL/FXCN]2 pcs of 810 top-bottom overlapping placement 0 Locked

    284 views
    3 replies
    Latest over 1 year ago
    by Nasser Mohammadi
<>