Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] 66AK2H12: Booting Linux on K2H board using NFS

    Part Number: 66AK2H12 How to boot and run (without flashing) on the K2H board?

  • [FAQ] EVMK2G: How to run UART Examples for DSP core on K2G EVM

    Part Number: EVMK2G How to build, run and test the K2G UART example projects in DSP core from TI-RTOS SDK?

  • [FAQ] SK-AM62: Steps to enable Expansion Header I2C and power

    Part Number: SK-AM62 Hello, I'm using the E3 SK-AM62 which has an I2C switch between the I2C-2 pins on the Expansion header and also uses a load switch on to enable 3.3V on the expansion header. I've been having a hard time getting the load switch…

  • [FAQ] TDA4VM: Best practices for version tracking for TI’s SDK

    Part Number: TDA4VM This FAQ is intended to provide general guidelines of version tracking on TIs PDK to make it easier to track and share the code changes between customers and TI support.

  • [FAQ] 66AK2G12: How to create "Target configuration" and do "Test connection" on 66AK2G12 EVM

    Part Number: 66AK2G12 Hi, How to create "Target configuration" and do "Test connection" on 66AK2G12 EVM ?

  • [FAQ] EVMK2GX: Build Linux for K2G - ARM

    Part Number: EVMK2GX How to build Linux for K2G - ARM? from the package "PROCESSOR-SDK-LINUX-K2G"

  • [FAQ] EVMK2GX: U-boot build steps for K2G

    Part Number: EVMK2GX How to build u-boot for K2G? from the package "PROCESSOR-SDK-LINUX-K2G".

  • [FAQ] SK-TDA4VM: How do I use the CAN bus headers on SK-TDA4VM using Edge AI SDK?

    Part Number: SK-TDA4VM Other Parts Discussed in Thread: TDA4VM The SK-TDA4VM has 4 CAN bus interface. How can these be used?

  • [FAQ] SK-TDA4VM: How do I enable and debug IMX390 + fusion board not working with Edge AI SDK

    Part Number: SK-TDA4VM I have connected the SK-TDA4VM board with fusion board and IMX390. I am following the SDK documentation on enabling the camera: https://software-dl.ti.com/jacinto7/esd/processor-sdk-linux-sk-tda4vm/08_02_00/exports/docs/getting_started…

  • [FAQ] PROCESSOR-SDK-J721E: How to use DRU channels for config data in VISS

    Part Number: PROCESSOR-SDK-J721E For heterogeneous camera processing, VISS internally uses UDMA channel for saving and restoring the configuration almost on every frame. This article explains how VISS driver can be changed to use DRU channels for saving…

View FAQ threads
  • Threads 198034 Discussions