TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DCC Tuning Tool V3.2 for VPAC on TDA4x and AM6xA Devices

    Gang Hua
    Gang Hua
    Hi everyone, DCC Tuning Tool V3.2 for TDA4x and AM6xA has been released in 09/2024. You may find it now in your secure resource section on ti.com. If you have no access or expired access, you may apply here -- http://www.ti.com/drr/opn/ADAS-SW-IMAGING…
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to enable main domain watchdog?

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Other Parts Discussed in Thread: TDA4VM The j721e/TDA4VM has SOC watchdog enabled. How to enable the same on J784s4?
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] AM64X/AM62X: How do I route the same GPIO bank interrupts to different destination cores?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 How do I route the same GPIO bank interrupts to different destination cores? Example: I want to route the GPIO0_37 pin interrupt to R5F0_0 and the GPIO0_38 pin interrupt to R5F0_1. when I was selecting the above pin combination…
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] AM625: Long Term Effects of Simultaneously Power-Down Sequencing of all Voltage Rails

    Stuart Baker
    Stuart Baker
    Part Number: AM625 I'm working with a customer that is using the TPS6521908 as their PMIC, and therefore, should in nearly all cases have a controlled power-down sequencing of all the AM62x voltage rails. However, it is still possible that they could…
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ]: Transitioning the GPIO userspace interface from SYSFS to Chardev

    Anshu Madwesh
    Anshu Madwesh
    This information applies to Linux SDK Version 9.0 and prior. For more up to date information, refer to this FAQ: https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1494485/faq-processor-sdk-getting-started-with-gpios-in-linux-using…
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM62: How to build initramfs into kernel Image

    Bin Liu
    Bin Liu
    Part Number: SK-AM62 There are cases the initramfs should be used for Linux root filesystem. Please see the kernel documentation < Documentation/filesystems/ramfs-rootfs-initramfs.rst > for the details of initramfs. There are two ways to use initramfs…
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to reduce the EthFW initialization time to avail CPSW H/W Switch functionality as soon as possible after the core boot up in Vision Apps use-case?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM How to reduce the EthFW initialization time to avail CPSW H/W Switch functionality as soon as possible after the core boot up in Vision Apps use-case?
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How do I enable CAN channels on Gateway/Ethernet Switch/Industrial (GESI) expansion card when using J721E EVM from Linux A72?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM How do I enable CAN channels on Gateway/Ethernet Switch/Industrial (GESI) expansion card when using J721E EVM from Linux A72?
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] How to set up an EtherCAT System with AM6xx MainDevice and AM64/AM243 SubDevice using CODESYS Development System

    Venkat Ranganathan
    Venkat Ranganathan
    Other Parts Discussed in Thread: UNIFLASH This FAQ walks the user through setting up an industrial networking EtherCAT system in CODESYS using an AM6xx MainDevice and one-or-more AM64x/AM243x SubDevice(s). Instructions are provided to set up MainDevice…
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: OpenVX Host on R5F and node Target on A72 (Linux)

    Nikhil Dasan
    Nikhil Dasan
    Part Number: TDA4VM How to run OpenVX Host on R5F and a node to run on A72 (Linux) as target?
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198362 Discussions
  • Answered

    SK-AM62P-LP: How can I toggle the DSI_GPIO0 or DSI_GPIO1 of TCA6424 I/O expander on the EVM ? 0 Locked

    134 views
    4 replies
    Latest 2 months ago
    by KH Leong
  • Suggested Answer

    TDA4AL-Q1: GPIO_socConfigIntrPath init fail in SDK0806 0 Locked

    379 views
    22 replies
    Latest 2 months ago
    by Neehar Sawant
  • Suggested Answer

    TDA4VEN-Q1: J722S tiny-rootfs problem 0 Locked

    119 views
    5 replies
    Latest 2 months ago
    by Keerthy J
  • Answered

    TMDXIDK5718: Request to exchange for another board 0 Locked

    156 views
    3 replies
    Latest 2 months ago
    by Josue Zamitiz-Ayala
  • Answered

    SK-AM62P-LP: how to decode local video file to dpi interface 0 Locked

    239 views
    9 replies
    Latest 2 months ago
    by dongcan Zhi
  • Answered

    TMS320C6748: OMAP Power Groups A, B and C 0 Locked

    130 views
    1 reply
    Latest 2 months ago
    by Heider Sati
  • Not Answered

    TDA4VM: c7000 compiler error 0 Locked

    232 views
    6 replies
    Latest 2 months ago
    by Sivadeep P R
  • Not Answered

    AM625-Q1: Autosar Integration on MCU R5F core 0 Locked

    136 views
    1 reply
    Latest 2 months ago
    by Krithika Ravi
  • Suggested Answer

    AM6442: TDMS64EVM +1 Locked

    57 views
    1 reply
    Latest 2 months ago
    by Teja Rowthu
  • Answered

    [FAQ] PROCESSOR-SDK-AM64X: How to program TCA6424A using SoC_I2C1 0 Locked

    1378 views
    4 replies
    Latest 2 months ago
    by Tushar Thakur
  • Not Answered

    AM62P: AM62P availability for proto and production quantity 0 Locked

    58 views
    0 replies
    Started 2 months ago
    by Prasad Achar
  • Answered

    PROCESSOR-SDK-AM64X: Help: Normal Bootflow vs combined Bootflow on TMDS64EVM 0 Locked

    118 views
    3 replies
    Latest 2 months ago
    by Meet Thakar
  • Answered

    TDA4VL-Q1: Gptimer 0 Locked

    223 views
    14 replies
    Latest 2 months ago
    by Tarun Mukesh Puvvada
  • Not Answered

    PROCESSOR-SDK-J721E: RTOS SDK 0 Locked

    98 views
    5 replies
    Latest 2 months ago
    by Tarun Mukesh Puvvada
  • Not Answered

    SK-TDA4VM: Runtime logs 0 Locked

    105 views
    2 replies
    Latest 2 months ago
    by komal k s
  • Suggested Answer

    SK-AM62P-LP: Writing and reading from OSPI fails 0 Locked

    137 views
    5 replies
    Latest 2 months ago
    by Bo Mellberg
  • Not Answered

    DRA821U: Switch console to UART5,DFU can not flash boot files 0 Locked

    104 views
    7 replies
    Latest 2 months ago
    by Gokul Praveen
  • Not Answered

    AUDIO-AM62D-EVM: AM62Dx – eCAP Interrupt Not Triggering While Measuring McASP Tx Clock 0 Locked

    114 views
    3 replies
    Latest 2 months ago
    by Swargam Anil
  • Answered

    J784S4XEVM: EVM reboot randomly 0 Locked

    98 views
    1 reply
    Latest 2 months ago
    by Winner Lin
  • Suggested Answer

    BEAGL-BONE-AI-64: Help with IPC Communication Between Cortex-A72 and C71x DSP using remoteproc and rpmsg 0 Locked

    101 views
    1 reply
    Latest 2 months ago
    by Tarun Mukesh Puvvada
<>