Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM625 Other Parts Discussed in Thread: AM62P ,
Tool/software:
Hi TI Experts,
Could you provide S-parameter and IBIS model of IO-buffer for performing simulations
Part Number: AM625
Tool/software:
Hi Team,
My customer is creating their PCB and have a few questions.
Is there any recommendations or recommended values (for interconnect length or CLK-to-DATA interconnect difference) for the peripherals below? Is there…
Part Number: AM625
Tool/software:
Hi Team,
My customer has questions about JTAG pulldown/pullup.
Regarding the TCK, TDI, TMS signals, is pullup required?
It does not seem to be mentioned in the datasheet and says in the link below that it depends on…
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62-LP
Tool/software:
Hi, My customer is using SD card boot only for development phase. For production, only QSPI boot is used. QSPI or SD card boot selection is done by DIP switch on the board. SD…
Part Number: AM62A7 Other Parts Discussed in Thread: SYSCONFIG
Tool/software:
From release 10.00.00.14 onwards, BBM has been implemented in TI Drivers for NAND Flash Parts.
AM62A MCU SDK: https://www.ti.com/tool/download/MCU-PLUS-SDK-AM62A/10.00.00.14
…
Part Number: TPS62867
Tool/software:
Hi Experts,
Customer is using the below device
The input is 3.6V - 5%
The output is 3.3V + 5%
Current 1-2 A.
Is there a min voltage difference that is required between the output and the input.
Regards,
Sreenivas…
