TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] J722SXH01EVM: Attempt to connect to XDS110 failed (on-board USB debugger)

    Neehar Sawant
    Neehar Sawant
    Part Number: J722SXH01EVM Tool/software: I have the following error when trying to connect XDS110 debugger and launch target configuration in CCS: How do I fix this?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM64x / AM243x / AM62Ax / AM62Px / AM62D-Q1 / AM62L - Bootmode implementation without isolation buffers

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62A-LP , AM62L , AM62P Tool/software: Hi TI Experts, Do you have suggestions to optimize the BOOTMODE configuration on custom board compared to implementation on the SK or the EVM schematics…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625SIP / AM625-Q1 / AM62Ax / AM62Px Custom board hardware design – CSI-2 capabilities

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, I have the below queries regarding the CSI-2 interface Supported data rate Does the CSI-2 interface provide provision for internal termination Links to useful threads Let me know your…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6442: Running Raw Serdes

    Tony Spagnolia
    Tony Spagnolia
    Part Number: AM6442 Tool/software: We have a desire to use the SERDES as a raw interface without a protocol on top. The idea would be to just run 8b/10b and limit our packet size to 10 -40 bits. Is this possible or do we need to run PCIE or USB using…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AH-Q1: How to edit/change ONNX graph to remove unsupported layers by TIDL and add supported ones

    Pratik Kedar
    Pratik Kedar
    Part Number: TDA4AH-Q1 Tool/software: I have ONNX graph with below mentioned layer structure. Which tools can i use to change the unsupported layer (HardSwish) to Supported ones ?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] SK-TDA4VM: No graphics acceleration on SDK 9.x in Wayland (Weston)

    JB LIM
    JB LIM
    Part Number: SK-TDA4VM Other Parts Discussed in Thread: TDA4VM Tool/software: Hi, TI Team I run an opencv example program(drawing and media play) in Wayland(western). But drawing(graphics) is little bit slow and media play occurs a stuttering frames…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM623: 4GB LPDDR4

    Kim Yue
    Kim Yue
    Part Number: AM623 Tool/software: Hi team, A customer wants to have 4GB LPDDR4 (single channel topology). They could not find 4GB 16-bit single-channel LPDDR4, there is only 2GB option. Can they use a 32-bit device and only connect one channel?…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62P: How to measure wakeup latency for Low Power Modes on AM62x/A/P

    Anshu Madwesh
    Anshu Madwesh
    Part Number: AM62P Tool/software: How can you measure the wakeup latency for Low Power Modes on AM62x/A/P? Low Power Mode's wakeup latency is the amount of time required from triggering a wakeup event to resuming normal operation. This FAQ shows to…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62x, AM62Ax, AM62D-Q1, AM62L, AM62Px, AM64x, AM243x, Custom board hardware design – How to handle Used / Unused Pins / Peripherals and add pullup or pulldown? (e.g. GPIOs, SERDES, USB, CSI, MMC (eMMC, SD-card), CSI, OLDI, DSI, CAP_VDDSx, .......

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, Is there any application note with information about how to connect IOs or Peripherals - Used or Unused Details on the connections to be done when used. When not used, should these IOs or Peripherals…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH-Q1: How to change the ATF to print on MCU_UART in SBL bootflow

    Nikhil Dasan
    Nikhil Dasan
    Part Number: TDA4VH-Q1 Tool/software: In the SBL bootflow, using BootApp, how to print ATF logs on MCU_UART or WKUP_UART?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198424 Discussions
  • Suggested Answer

    C5535 eZdsp for usb missing project files so debugger does not track source code 0 Locked

    1802 views
    18 replies
    Latest over 12 years ago
    by Maxime GUYON
  • Not Answered

    How to flash LED to indicate USB HDD/Storage access 0 Locked

    180 views
    0 replies
    Started over 12 years ago
    by aaron1008
  • Answered

    Cache_wb() doesn't work 0 Locked

    644 views
    1 reply
    Latest over 12 years ago
    by ToddMullanix
  • Answered

    HOW TO DO EDMA programming on DSP Processor of OMAPL138 0 Locked

    177 views
    3 replies
    Latest over 12 years ago
    by Radhesh Bhat
  • Answered

    Setting resolution via fbset/xrandr 0 Locked

    1749 views
    2 replies
    Latest over 12 years ago
    by Yegor Yefremov
  • Not Answered

    LCD controller driver (da8xx) unable to allocate memory for framebuffer 0 Locked

    879 views
    2 replies
    Latest over 12 years ago
    by Andrea Marson
  • Not Answered

    Error in Debug Session in Am-1808 with CCS and Black Hawk USB 100 V2 0 Locked

    223 views
    0 replies
    Started over 12 years ago
    by usama yaseen
  • Answered

    DM36X IPNC color to black 0 Locked

    201 views
    4 replies
    Latest over 12 years ago
    by Minglei Li
  • Not Answered

    Cache coherency of L2SRAM of coreX in coreY? 0 Locked

    290 views
    2 replies
    Latest over 12 years ago
    by Alberto Chessa
  • Answered

    OMAP - L137 EVM boot 0 Locked

    234 views
    2 replies
    Latest over 12 years ago
    by HRi
  • Not Answered

    DM368 decoding 1080P (not 1080I)issue 0 Locked

    341 views
    0 replies
    Started over 12 years ago
    by yangchar
  • Not Answered

    dm648 video port capture support 16-bit ycbcr? 0 Locked

    310 views
    0 replies
    Started over 12 years ago
    by Aen
  • Not Answered

    Test sequences 0 Locked

    243 views
    1 reply
    Latest over 12 years ago
    by Yashwant Dutt
  • Answered

    DM368 HPIC register read problem for HPI interface 0 Locked

    498 views
    2 replies
    Latest over 12 years ago
    by cwchang
  • Not Answered

    DVRRDK_03.00.00.00's VideoM3 local loopBack demo is not running on DM8148 EVM 0 Locked

    346 views
    2 replies
    Latest over 12 years ago
    by Shabbir Limdiwala
  • Not Answered

    TIViddec2 codec playing choppy for QVGA 0 Locked

    233 views
    1 reply
    Latest over 12 years ago
    by Yashwant Dutt
  • Answered

    IVA mapping 0 Locked

    272 views
    3 replies
    Latest over 12 years ago
    by HardikShah
  • Not Answered

    [WinCE6&7]After 10~30 times plug in-and-out... AM3517 EVM and AM335x EVM USB HOST will not working. 0 Locked

    187 views
    0 replies
    Started over 12 years ago
    by WTMEC_FoneC
  • Not Answered

    DM8168 EMAC loopback mode 0 Locked

    329 views
    1 reply
    Latest over 12 years ago
    by Mugunthan V N
  • Answered

    DDR SRIO Reference Clock issue 0 Locked

    473 views
    2 replies
    Latest over 12 years ago
    by Bill Taboada
<>