TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197688 Discussions
  • Not Answered

    TNET1060 Part Number 0 Locked

    153 views
    1 reply
    Latest over 14 years ago
    by Juliana Mansell
  • Not Answered

    OMAP5912 POR & Warm Reset Timing 0 Locked

    237 views
    0 replies
    Started over 14 years ago
    by Ken Perdue
  • Not Answered

    CSL EDMA3 with interrupts 0 Locked

    445 views
    2 replies
    Latest over 14 years ago
    by Raghu Nambiath
  • Not Answered

    5507 to 5509A migration 0 Locked

    276 views
    1 reply
    Latest over 14 years ago
    by Juliana Mansell
  • Answered

    SMSC9221 chip reset and recovery 0 Locked

    1099 views
    6 replies
    Latest over 14 years ago
    by Zack Zadecki
  • Answered

    Can the data received by VPFE 0 Locked

    271 views
    1 reply
    Latest over 14 years ago
    by Nagabhushana
  • Not Answered

    designing omap3530 with non-pop memory 0 Locked

    205 views
    0 replies
    Started over 14 years ago
    by Soon Hung Leng
  • Not Answered

    Configuration of gpios on dm36x 0 Locked

    112 views
    0 replies
    Started over 14 years ago
    by siva prasad
  • Answered

    Getting DM3730 DSP load 0 Locked

    286 views
    1 reply
    Latest over 14 years ago
    by Tao Zhang
  • Answered

    LCD Driver query on TI Sitara EVK 0 Locked

    2838 views
    21 replies
    Latest over 14 years ago
    by Tao Zhang
  • Not Answered

    AM1808 how to use MCASP receiver 0 Locked

    400 views
    4 replies
    Latest over 14 years ago
    by Power Pan
  • Answered

    anybody could tell how to use alarm ? 0 Locked

    260 views
    4 replies
    Latest over 14 years ago
    by Power Pan
  • Not Answered

    L2 Preload engine (PLE) example or documentation 0 Locked

    750 views
    3 replies
    Latest over 14 years ago
    by Jeff L
  • Answered

    Clock_start() and clock_stop() with Clock_Handle problem ; 0 Locked

    2151 views
    2 replies
    Latest over 14 years ago
    by Sam71411
  • Answered

    DDR2 w/o Termination 0 Locked

    278 views
    4 replies
    Latest over 14 years ago
    by Thomas Wappler
  • Not Answered

    Sound Driver as seperate module 0 Locked

    176 views
    0 replies
    Started over 14 years ago
    by Parthipan Krishnan
  • Not Answered

    How to change PLL setings of TMS320DM6467? 0 Locked

    245 views
    2 replies
    Latest over 14 years ago
    by Bhupesh Patil
  • Not Answered

    DSP starter kit with 4 simultaneously sampling audio inputs. 0 Locked

    252 views
    0 replies
    Started over 14 years ago
    by Jan Minck
  • Not Answered

    Setting up boundary scan for AM3505 0 Locked

    221 views
    0 replies
    Started over 14 years ago
    by Matthew Stevenson
  • Answered

    IPC MessageQ Example fails on c6472 device cycle accurate simulator 0 Locked

    542 views
    7 replies
    Latest over 14 years ago
    by Nizamudheen A
<>