TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198274 Discussions
  • Answered

    Increase the frame rate of v4l2 capture 0 Locked

    1600 views
    5 replies
    Latest over 14 years ago
    by Manjunath Hadli56783
  • Answered

    Need help with SPI programming in XLDR 0 Locked

    481 views
    4 replies
    Latest over 14 years ago
    by muragesh math13999
  • Answered

    how to switch to power state 0 when wake up from suspend mode 0 Locked

    386 views
    2 replies
    Latest over 14 years ago
    by muragesh math13999
  • Answered

    EDMA3 is not working properly with codec engine2.10.02 0 Locked

    2024 views
    14 replies
    Latest over 14 years ago
    by Brad Griffis
  • Not Answered

    mpeg4 decoding problem 0 Locked

    277 views
    2 replies
    Latest over 14 years ago
    by Mehmet Kurnaz57621
  • Answered

    L138 Experimenter Board hang on NFS boot 0 Locked

    561 views
    1 reply
    Latest over 14 years ago
    by Alister Sibbald56662
  • Not Answered

    DSP Link / DSP Boot Issue 0 Locked

    323 views
    6 replies
    Latest over 14 years ago
    by Rahul Prabhu
  • Answered

    USB Issues 0 Locked

    741 views
    2 replies
    Latest over 14 years ago
    by Dave Pulvermacher
  • Not Answered

    Mulplication + Intrinsics 0 Locked

    665 views
    4 replies
    Latest over 14 years ago
    by Rahul Prabhu
  • Not Answered

    GND separation in PCB design 0 Locked

    532 views
    1 reply
    Latest over 14 years ago
    by Tai Nguyen
  • Not Answered

    cyclic thread 0 Locked

    117 views
    0 replies
    Started over 14 years ago
    by Annie Zhang
  • Suggested Answer

    CROPPING WHILE ROTATION 0 Locked

    254 views
    3 replies
    Latest over 14 years ago
    by sujit mahapatro
  • Answered

    PRU power consumption + Linux system wake up 0 Locked

    504 views
    1 reply
    Latest over 14 years ago
    by clam
  • Not Answered

    [OMAPL138] hex470 boot table format 0 Locked

    1421 views
    18 replies
    Latest over 14 years ago
    by Brad Griffis
  • Not Answered

    AM3517 BLUETOOTH AND WIFI 0 Locked

    867 views
    3 replies
    Latest over 14 years ago
    by JJD
  • Answered

    Disable preemption 0 Locked

    773 views
    1 reply
    Latest over 14 years ago
    by Alan DeMars
  • Answered

    Problem with NOR boot and debugging 1st level bootloader 0 Locked

    1135 views
    9 replies
    Latest over 14 years ago
    by Martin Kaul
  • Not Answered

    Testing with the SRIO 0 Locked

    178 views
    2 replies
    Latest over 14 years ago
    by bschulz
  • Answered

    TI WinCE BSP 6.13 - USB3320 prevents USB OTG/Function/ActiveSync from running 0 Locked

    458 views
    2 replies
    Latest over 14 years ago
    by Jatin Jain
  • Not Answered

    Using Video DACs as Outputs 0 Locked

    1267 views
    11 replies
    Latest over 14 years ago
    by Daniel Allred
<>