TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198138 Discussions
  • Answered

    LSP 3.10 DaVinci Linux Drivers 0 Locked

    180 views
    1 reply
    Latest over 15 years ago
    by Bryan Evenson
  • Not Answered

    an error occur when I change the image1_copy's argorithm in omap3530 dvsdk's codec engine 0 Locked

    299 views
    0 replies
    Started over 15 years ago
    by KuangRen
  • Not Answered

    Delay between 2 dm6467t's connected through network, processing h264 0 Locked

    185 views
    2 replies
    Latest over 15 years ago
    by shaoyang chen
  • Answered

    GPIO driver implementation bug 0 Locked

    546 views
    2 replies
    Latest over 15 years ago
    by Ravindra
  • Not Answered

    OMAP3530 and NOR Flash (Strataflash) 0 Locked

    337 views
    9 replies
    Latest over 15 years ago
    by Tien Ngo
  • Answered

    How to Improve WinCE BSP SDCARD Performance for OMAP3530 0 Locked

    714 views
    4 replies
    Latest over 15 years ago
    by Ravindra
  • Not Answered

    trouble with dm365-270MHZ TEDDR2 0 Locked

    236 views
    0 replies
    Started over 15 years ago
    by Ellen
  • Not Answered

    Shared memory (variables) 0 Locked

    1165 views
    15 replies
    Latest over 15 years ago
    by RandyP
  • Answered

    How to use ECM in DSP/BIOS 0 Locked

    1188 views
    2 replies
    Latest over 15 years ago
    by jay chou
  • Suggested Answer

    NFS boot of DM365 IPNC-MT5 0 Locked

    5214 views
    29 replies
    Latest over 15 years ago
    by swinter
  • Suggested Answer

    debug multithreaded application in Linux 0 Locked

    835 views
    3 replies
    Latest over 15 years ago
    by Kiung Chung Wong
  • Not Answered

    Reserving different UARTs for DSP 0 Locked

    179 views
    3 replies
    Latest over 15 years ago
    by Sudhakar Rajashekhara
  • Discussion

    Regarding TI : Is OMAP3530 use Fixed point or Floating Point Locked

    1316 views
    3 replies
    Latest over 15 years ago
    by BrandonAzbell
  • Not Answered

    TMS320C5505 eZdsp PCB revision ? 0 Locked

    345 views
    2 replies
    Latest over 15 years ago
    by Mark M
  • Answered

    DAC parameters for C5505 0 Locked

    304 views
    5 replies
    Latest over 15 years ago
    by Steve Tsang
  • Not Answered

    c64+ edma transfer question!!! 0 Locked

    199 views
    1 reply
    Latest over 15 years ago
    by Brad Griffis
  • Not Answered

    SDRAM question in OMAP-L138 0 Locked

    1325 views
    8 replies
    Latest over 15 years ago
    by Mukul Bhatnagar
  • Not Answered

    DM648 use GMM with VLIB 0 Locked

    280 views
    1 reply
    Latest over 15 years ago
    by Senthil Kumar Yogamani
  • Answered

    OMAP-L138 ARM core connection abnormal by emulator and same register's value is differece between ARM and DSP 0 Locked

    559 views
    4 replies
    Latest over 15 years ago
    by tlee
  • Answered

    EMIFA SDRAM interface 0 Locked

    385 views
    7 replies
    Latest over 15 years ago
    by tlee
<>