TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198300 Discussions
  • Answered

    EVM6472 0 Locked

    267 views
    1 reply
    Latest over 15 years ago
    by Sid
  • Answered

    Migrating from TMS320DM6441-519 to TMS320DM6446-810 0 Locked

    278 views
    1 reply
    Latest over 15 years ago
    by Paul.Yin
  • Not Answered

    virtual and physical address space 0 Locked

    273 views
    1 reply
    Latest over 15 years ago
    by JamesJ35562
  • Answered

    Windows CE Loading Problem 0 Locked

    538 views
    7 replies
    Latest over 15 years ago
    by behnam azimi
  • Not Answered

    CCDC/ISP usage adversely affects DSP performance? 0 Locked

    237 views
    1 reply
    Latest over 15 years ago
    by JamesJ35562
  • Answered

    Problem Debugging Custom UBL/BL solution for DM365 0 Locked

    445 views
    4 replies
    Latest over 15 years ago
    by Scott Cloutier
  • Answered

    OMAP L1x USB 2.0 Throughput 0 Locked

    272 views
    2 replies
    Latest over 15 years ago
    by William Shaffer
  • Answered

    AM17x/18x USB 2.0 Throughput 0 Locked

    247 views
    2 replies
    Latest over 15 years ago
    by William Shaffer
  • Suggested Answer

    Building a Standalone Project from DVSDK 3.10 0 Locked

    476 views
    3 replies
    Latest over 15 years ago
    by John Anderson
  • Answered

    DM355 USING VIDEO DECODER TPV5146 0 Locked

    634 views
    8 replies
    Latest over 15 years ago
    by Steve Clynes
  • Answered

    C6713 standlone 0 Locked

    916 views
    5 replies
    Latest over 15 years ago
    by RandyP
  • Answered

    AISgen 0 Locked

    572 views
    3 replies
    Latest over 15 years ago
    by Kurt Jensen
  • Not Answered

    HD DVD connection with DM365 EVM 0 Locked

    550 views
    5 replies
    Latest over 15 years ago
    by Steve Clynes
  • Suggested Answer

    Problem with integrate MPEG4 Encoder into DVSDK? 0 Locked

    599 views
    5 replies
    Latest over 15 years ago
    by Cesar
  • Answered

    OMAPL138 Booting from NOR Flash 0 Locked

    649 views
    5 replies
    Latest over 15 years ago
    by Marc48067
  • Answered

    stack usage in task 0 Locked

    458 views
    5 replies
    Latest over 15 years ago
    by MarkGrosen
  • Not Answered

    Building stand-along TI gstreamer plug-in 0 Locked

    166 views
    1 reply
    Latest over 15 years ago
    by Brijesh Singh
  • Not Answered

    Lab View Support 0 Locked

    263 views
    1 reply
    Latest over 15 years ago
    by Lawrence Ronk
  • Not Answered

    Does DM365 Linux driver support SPI slave mode? 0 Locked

    464 views
    2 replies
    Latest over 15 years ago
    by Bryan Wu
  • Answered

    Is FSYNC required without AIF? 0 Locked

    386 views
    3 replies
    Latest over 15 years ago
    by ArunMani
<>