Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: TMUX1308-Q1 Other Parts Discussed in Thread: TMUX1308 , AM625 , TMUX1308A , SN74LV4051A , TMUX1308A-Q1 , ADC121S101 , , TPS65224-Q1
Tool/software:
Hi Team,
TMUX1308 EN and control A0..A2 is being controlled by AM625 Sitara SOC.
SOC IO buffers are…
Part Number: PROCESSOR-SDK-AM64X Tool/software: Hi,
I am designing my custom board using AM64x/AM243x + MCUSDK. But not using PHY provided on EVM/LP board.
Can you provide guidance how to do this?
Regards
Part Number: AM6412
Tool/software:
Hello Users,
Many users are asking to trigger DMA with the help of GPIO on AM64X/AM243 and AM62X devices.
So, I have created an example of this solution on AM64X and the procedure is the same for all other devices. …
Part Number: PROCESSOR-SDK-AM64X Tool/software: Hi, can we use a timer to generate a PWM? If so, how could we control/change its frequency and duty cycle while running?
Part Number: AM623
Tool/software:
Hi Expert,
Power-Up Sequencing refers to the datasheet to set up, but now I have a question about the power-up timing of the VPP voltage.
And the Figure 7-5. Power-Up Sequencing graphic shows Hi-Z. I don’t quite understand…
Part Number: AM6412
Tool/software:
In AM64x/AM243 devices, we are using DMSC core (M3 core) for doing Resets, individual core Reset, SOC Reset, Core or IP frequency settings and resource allocation and security operations .
We need to use SCI client…
Part Number: TDA4VH-Q1 Tool/software: Provide the steps to integrate SDL functional safety modules such as BIST, POK, VTM and TOG with the PDK Boot Application.
Part Number: AM62A3
Tool/software:
Hi,
a customer is using the AM62A and connects to an external ethernet switch with the RGMII interface. We are looking at the appnote
https://www.ti.com/lit/an/sprad07/sprad07.pdf
The design currently does not have…
Part Number: TDA4VM Other Parts Discussed in Thread: SYSCONFIG
Tool/software:
How do we avoid UDMA resource conflict issues when integrating the MCAL Eth module with other modules?