TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197692 Discussions
  • Suggested Answer

    httpd for AM335X Linux 0 Locked

    244 views
    3 replies
    Latest over 11 years ago
    by Miroslav Kiradzhiyski XID
  • Suggested Answer

    CLK questions on Keystone 0 Locked

    163 views
    1 reply
    Latest over 11 years ago
    by Bill Taboada
  • Not Answered

    am335x setenv 0 Locked

    778 views
    3 replies
    Latest over 11 years ago
    by Miroslav Kiradzhiyski XID
  • Answered

    STB/PVR with DM8168 0 Locked

    510 views
    4 replies
    Latest over 11 years ago
    by Christos Birbas
  • Answered

    Processor clock speed 0 Locked

    467 views
    2 replies
    Latest over 11 years ago
    by Raja
  • Not Answered

    115200 UART problem in 6713 0 Locked

    427 views
    3 replies
    Latest over 11 years ago
    by Sivaraj Kuppuraj
  • Answered

    AM335x SGX Display Troubles 0 Locked

    742 views
    3 replies
    Latest over 11 years ago
    by Miroslav Kiradzhiyski XID
  • Not Answered

    Reset Management Confusion?? 0 Locked

    307 views
    3 replies
    Latest over 11 years ago
    by Cvetolin Shulev-XID
  • Answered

    The USB Interface of the Extension can not work 0 Locked

    1126 views
    6 replies
    Latest over 11 years ago
    by Bhanuprakash Nayak
  • Not Answered

    EtherCAT 0 Locked

    358 views
    1 reply
    Latest over 11 years ago
    by Frank Walzer
  • Not Answered

    OMAP-L138 C6748 USB0 0 Locked

    561 views
    2 replies
    Latest over 11 years ago
    by Shankari G
  • Answered

    How to receive ARP requests with NetCp 0 Locked

    1262 views
    4 replies
    Latest over 11 years ago
    by manjushree k
  • Answered

    Bad fragmented UDP message transmission 0 Locked

    3540 views
    18 replies
    Latest over 11 years ago
    by JPH-FR
  • Answered

    bus_find_device_by_name(&mdio_bus_type, NULL, bus_id); failed 0 Locked

    1858 views
    2 replies
    Latest over 11 years ago
    by trichet christophe
  • Answered

    Linaro toolchain path in ti-sdk-am335x-evm-07.00.00.00 0 Locked

    968 views
    4 replies
    Latest over 11 years ago
    by Gangadhar Gangu
  • Answered

    OMAP mcbsp routing 0 Locked

    915 views
    1 reply
    Latest over 11 years ago
    by Yanko Todorov-XID
  • Not Answered

    Qt OpenGL compilation for AM335X Starter Kit 0 Locked

    522 views
    3 replies
    Latest over 11 years ago
    by Miroslav Kiradzhiyski XID
  • Not Answered

    Clear CPU caches for reading system timer on beaglebone 0 Locked

    691 views
    7 replies
    Latest over 11 years ago
    by Miroslav Kiradzhiyski XID
  • Not Answered

    invalidate L1D cache , after DMA transfer 0 Locked

    413 views
    3 replies
    Latest over 11 years ago
    by Genady Kagan
  • Not Answered

    How to change the muti-ch video input to a single-ch output and then send the single-ch to enclink? 0 Locked

    207 views
    2 replies
    Latest over 11 years ago
    by RWTH
<>