TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198134 Discussions
  • Not Answered

    Bcp_init() or Bcp_initDevice()? 0 Locked

    175 views
    1 reply
    Latest over 12 years ago
    by Nitin Sakhuja
  • Answered

    AMDSK Software Developers Guide v5.05 0 Locked

    496 views
    3 replies
    Latest over 12 years ago
    by R11
  • Answered

    V4L2 decoder connecting /dev/video1 to the hardware video port 0 Locked

    1031 views
    4 replies
    Latest over 12 years ago
    by Dave Helsley1
  • Answered

    loader_exit does not contain frame information 0 Locked

    3348 views
    11 replies
    Latest over 12 years ago
    by Rick Faszold
  • Not Answered

    C5515 DMA interrupt and status bit 0 Locked

    260 views
    1 reply
    Latest over 12 years ago
    by Vasantha K
  • Answered

    How do I use the full 512 MB space with DDR2? 0 Locked

    247 views
    1 reply
    Latest over 12 years ago
    by Antony Samsunil
  • Answered

    U-Boot will not start after SPL is loaded by NAND. 0 Locked

    2636 views
    2 replies
    Latest over 12 years ago
    by Chad Graham1
  • Answered

    I am not to open FAXLIB_C55_Users_Manual.chm 0 Locked

    494 views
    10 replies
    Latest over 12 years ago
    by lding
  • Not Answered

    OMAP L137 highly unstable 0 Locked

    1368 views
    9 replies
    Latest over 12 years ago
    by Zhe Ji
  • Not Answered

    The secrets of the CVDD powered for the TMSC6678?? 0 Locked

    871 views
    5 replies
    Latest over 12 years ago
    by Tom Johnson 16214
  • Answered

    Can't set resolution of /dev/fb2 to 1080p 0 Locked

    1316 views
    1 reply
    Latest over 12 years ago
    by _Ralph_
  • Answered

    C6203B RSV pins 0 Locked

    204 views
    1 reply
    Latest over 12 years ago
    by BrandonAzbell
  • Not Answered

    DM368 IPNC - ONVIF code crashes / SIGSEGVs + some questions 0 Locked

    686 views
    0 replies
    Started over 12 years ago
    by Bob The Gerbil
  • Not Answered

    connecting TMS320C6670 and PC via Ethernet 0 Locked

    149 views
    1 reply
    Latest over 12 years ago
    by lding
  • Answered

    only TPCC_2 in CSL of EDMA3 on C6657? 0 Locked

    370 views
    1 reply
    Latest over 12 years ago
    by Chad Courtney
  • Not Answered

    DM8148 RDK video shaking 0 Locked

    464 views
    7 replies
    Latest over 12 years ago
    by bioz
  • Not Answered

    OMAP 138 - help debugging arbitrary memory corruption in DSP DDR space 0 Locked

    667 views
    5 replies
    Latest over 12 years ago
    by Aníbal Pinto
  • Answered

    Using internal M3 timer to generate frame request and strobe signal 0 Locked

    420 views
    8 replies
    Latest over 12 years ago
    by Eli Balta
  • Discussion

    Audio loop with SYS BIOS on LCDK OMAP L138 problem Locked

    543 views
    1 reply
    Latest over 12 years ago
    by Tom Kopriva
  • Not Answered

    DM8148 - Cfg Registers 0 Locked

    185 views
    1 reply
    Latest over 12 years ago
    by Pavel Botev
<>