TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] EDGE-AI-STUDIO: Is SDK version important for Edge AI and TI Deep learning (TIDL) with C7x on AM6xA SoCs [AM62A, AM67A, AM68A, AM68PA, AM69A]?

    Reese Grimsley
    Reese Grimsley
    Part Number: EDGE-AI-STUDIO Other Parts Discussed in Thread: AM68A , AM67A , SK-AM62A-LP Tool/software: We receive frequent queries related to SDK versions and TI Deep Learning (TIDL). Please find a series of relevant FAQ topic below. Note that these…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to adjust ALE classifier/policer partition in ETHFW

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: TDA4VH Tool/software: The number of user configurable ALE classifier/policer entries are limited in ETHFW by dividing them in to multiple partitions, how to adjust those partitions?
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to SOC data sheet Pin Attributes Excel format

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM6442 Other Parts Discussed in Thread: AM625SIP , AM62P , AM62L Tool/software: Hi TI Experts, Can you supply the pin list of the SOC in excel format?
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62Px / AM62D-Q1 / AM62L / AM64x / AM243x Design Recommendations / Custom board hardware design - Drive Strength Configuration for SDIO and LVCMOS I/Os

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM62A7 , Tool/software: Hi TI Experts, I have the below query AM62A7: How can we change the drive strength of the SPI interface AM625: How to change the drive strength of the ethernet interface…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL-Q1: ECC Testing Procedure for Inaccessible RAM IDs

    Josiitaa RL
    Josiitaa RL
    Part Number: TDA4VL-Q1 Tool/software: Does the SDL ECC test cover error injection tests on the inaccessible endpoints? If not, what is the testing procedure for these endpoints?
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH-Q1: ECC Testing Procedure for Inaccessible RAM IDs

    Josiitaa RL
    Josiitaa RL
    Part Number: TDA4VH-Q1 Tool/software: Does the SDL ECC test cover error injection tests on the inaccessible endpoints? If not, what is the testing procedure for these endpoints?
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP: MCU_PORz input slew rate

    Tony Tang
    Tony Tang
    Part Number: AM623 Other Parts Discussed in Thread: AM625 Tool/software: Usually add RC filter on RESET signal to anti noise, but the slew rate requirement of RESET signal on AM62x datasheet is quite sharp, on customer board it is about 10V-100V/ms…
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM623: MMC0 HS200 slew rate

    Tony Tang
    Tony Tang
    Part Number: AM623 Tool/software: #1. Did not find MMC0 HS200 slew rate data in datasheet timing section, so section 7.8.6 LVCMOS Electrical Characteristics data applies? #2. The Min vale: 18f or 1.8E+6, the two value are quite different, 18f=18x200MHz…
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] Guideline on the Initial Software Post on E2E

    Bin Liu
    Bin Liu
    When posting a new software inquiry on the TI E2E forum, please follow this guideline for the initial post. Describing the Problem Using the following list of questions as the template, copy and paste the questions to your post, and answer them if…
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM67A: Enabling CSI2 sensors via fusion board on AM6x

    Fabiana Jaimes
    Fabiana Jaimes
    Part Number: AM67A Other Parts Discussed in Thread: SK-AM69 , SK-AM68 , AM67 , SK-TDA4VM Tool/software: How can I enable CSI2 sensors via fusion boards such as Arducam V3Link or fusion 1 daughter board (EVM577PFUSION-V1-0)?
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198418 Discussions
  • Not Answered

    UART0 Boot with HW flow control 0 Locked

    926 views
    15 replies
    Latest over 14 years ago
    by Brad Griffis
  • Answered

    Cannot run USB and GPT at the same time 0 Locked

    317 views
    3 replies
    Latest over 14 years ago
    by Andreas Weishaupt
  • Answered

    EVM6472 emac1 don't work 0 Locked

    394 views
    5 replies
    Latest over 14 years ago
    by Ruben Liber
  • Not Answered

    DM355 booting issues 0 Locked

    316 views
    7 replies
    Latest over 14 years ago
    by Sudarshan ns
  • Answered

    Need help with persistent registry 0 Locked

    471 views
    1 reply
    Latest over 14 years ago
    by DavidVescovi
  • Not Answered

    VPFE progressive capture problem 0 Locked

    636 views
    5 replies
    Latest over 14 years ago
    by Tarasova Tanya
  • Not Answered

    Dose the DM365 IPNC support frame buffer display? 0 Locked

    406 views
    0 replies
    Started over 14 years ago
    by yanbin yue
  • Answered

    UnderRun/OverRun USB Error handling in C55x5 0 Locked

    332 views
    3 replies
    Latest over 14 years ago
    by Christos Nikolaou12204
  • Not Answered

    C5510 IO port register at 0x0000Fh 0 Locked

    226 views
    1 reply
    Latest over 14 years ago
    by Peter Chung
  • Answered

    Forum tag for I2C 0 Locked

    202 views
    1 reply
    Latest over 14 years ago
    by Daniel Allred
  • Not Answered

    Verification on PRU delivering interrupts to itself. 0 Locked

    151 views
    1 reply
    Latest over 14 years ago
    by melissaw
  • Answered

    DM6467T Reverse Migration to DM6467 0 Locked

    272 views
    3 replies
    Latest over 14 years ago
    by Helmut Forren
  • Not Answered

    Error while loading modules to the dm365 target board 0 Locked

    190 views
    1 reply
    Latest over 14 years ago
    by John Anderson
  • Not Answered

    OMAP Off Mode Using More Power than Retention 0 Locked

    428 views
    2 replies
    Latest over 14 years ago
    by Chris Read
  • Not Answered

    Action of DM356 VENC HSync, Vsync registers in non-standard mode 0 Locked

    342 views
    0 replies
    Started over 14 years ago
    by Jon Nicoll
  • Answered

    TVP5147 Initialisation Issues on EVM6437 0 Locked

    365 views
    4 replies
    Latest over 14 years ago
    by Peter Rose
  • Not Answered

    Sound dropping on gstrearmer-ti with DM355-EVM 0 Locked

    324 views
    1 reply
    Latest over 14 years ago
    by Jeff Hayes
  • Answered

    ibis for dm365 0 Locked

    323 views
    6 replies
    Latest over 14 years ago
    by Miguel A. Alanis
  • Not Answered

    720p h.264 encoding with reduced frequency? 0 Locked

    405 views
    3 replies
    Latest over 14 years ago
    by Miguel A. Alanis
  • Not Answered

    unused printf in map file taking up flash space 0 Locked

    795 views
    6 replies
    Latest over 14 years ago
    by Brad Griffis
<>