TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Amplifiers

Amplifiers

Amplifiers forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask technical support questions on everything from precision and general purpose operational amplifiers (op amps) to instrumentation and differential amplifiers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] INA250: Can I use the INA250 inline with a PWM signal?

    Harsha Munikoti
    Harsha Munikoti
    Part Number: INA250 Other Parts Discussed in Thread: INA240 , INA253 Can I use the INA250 inline with a PWM signal?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA250: Where can I find the user's guide for the INA250EVM with just one A2 device?

    Harsha Munikoti
    Harsha Munikoti
    Other Parts Discussed in Thread: INA250EVM I have a version of the INA250EVM from TI that is different than the one shown on the product page. The board I have has a single INA250A2 unit installed on it. Is there a user's guide for this board?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA210: What is the difference between the INA21xA, INA21xB, and INA21xC devices?

    Manuel Chavez
    Manuel Chavez
    Part Number: INA210 There are various INA21xA/B/C devices. Why are the trailing letters different?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA199: What is the difference between the INA199A, INA199B and INA199C devices?

    Manuel Chavez
    Manuel Chavez
    Part Number: INA199 There are multiple versions of the INA199, ending with A#, B#, and C#. What is different between versions?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA199: Some plots in the data sheet are noted as only for INA199A3. What about INA199A1 and INA199A2?

    Manuel Chavez
    Manuel Chavez
    Part Number: INA199 The INA199 data sheet says typical characteristic plots were measured with the INA199A3. Are curves for the INA199A1 and INA199A2 identical?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA3221: Input Bias Current & Impedance Specs for Bus Voltage Monitors

    Peter Iliya
    Peter Iliya
    Part Number: INA3221 Other Parts Discussed in Thread: INA219 , INA231 , INA230 , INA226 , INA220 Some power monitors contain "input bias current || input impedance" specifications. How do these properties affect design and implementation of these devices…
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA190: How Offset (Vos) and Bias Currents (IB) Affect Low Current Measurements

    Peter Iliya
    Peter Iliya
    Part Number: INA190 Other Parts Discussed in Thread: INA240 , INA138 , INA216 , INA270 , INA193 , INA203 , INA200 , INA226 , INA170 , LMP8645 , INA223 , INA282 , INA210 , INA199-Q1 , INA180 , INA181 , INA121 What are the design considerations when making…
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA199: Does power sequencing for my current shunt monitor matter?

    Patrick Simmons
    Patrick Simmons
    Part Number: INA199 I expect that when I turn on my system, there will be a delay between when my microcontroller is ready for measurement and when my INA199 is properly powered on. Will this produce errors in my microcontroller readings?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA199: Dealing with device protection when you can't exceed -0.3V

    Mitch M
    Mitch M
    Part Number: INA199 How do I protect against reverse current when I can only allow my signal to be 0.3V below ground?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
  • [FAQ] INA199: Closed Loop Output Impedance and Output Compensation for Capacitive Load Stability

    Mitch M
    Mitch M
    Part Number: INA199 Other Parts Discussed in Thread: TINA-TI , How do I use the closed loop output impedance (Zout) to stabilize the output of a current sense amplifier with a capacitive load?
    • Answered
    • over 7 years ago
    • Amplifiers
    • Amplifiers forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    AMC1200: Calculation of voltage filter pole when AMC1200 is used 0 Locked

    258 views
    3 replies
    Latest over 2 years ago
    by Alexander Smith
  • Suggested Answer

    INA293: Questions concerning INA293 commissioning 0 Locked

    353 views
    1 reply
    Latest over 2 years ago
    by Javier Contreras4
  • Suggested Answer

    LM6211: Rejectable surface crack and delamination's on lead fingers found during DPA, acoustic microscopy 0 Locked

    576 views
    1 reply
    Latest over 2 years ago
    by Ashley Kang
  • Suggested Answer

    OPA2625: Right alternative for ADA4807-2ACPZ-R2? 0 Locked

    856 views
    7 replies
    Latest over 2 years ago
    by Bharat Agrawal60
  • Answered

    OPA4277-EP: Junction-to-Case (Bottom) 0 Locked

    393 views
    3 replies
    Latest over 2 years ago
    by Raymond Zhang1
  • Not Answered

    Is there a design : Output voltage limiter circuit? 0 Locked

    1260 views
    3 replies
    Latest over 2 years ago
    by kai klaas69
  • Answered

    THS7316: Enhance VGA signals quality 0 Locked

    1560 views
    12 replies
    Latest over 2 years ago
    by kai klaas69
  • Answered

    OPA376: OPA376 issue in high temperature 0 Locked

    1068 views
    16 replies
    Latest over 2 years ago
    by Luis Chioye
  • Answered

    TLV1821: Parts marking question for TLV1821DBVR 0 Locked

    412 views
    6 replies
    Latest over 2 years ago
    by Chi Nguyen1
  • Answered

    INA226: An error occurred while reading the registers in loop 0 Locked

    514 views
    6 replies
    Latest over 2 years ago
    by Castrense Nigrelli
  • Suggested Answer

    AMC1400-Q1: Circuit design recommendation 0 Locked

    520 views
    1 reply
    Latest over 2 years ago
    by Alexander Smith
  • Answered

    LM158QML-SP: NC pins 0 Locked

    395 views
    5 replies
    Latest over 2 years ago
    by Gerasimos Madalvanos
  • Not Answered

    THS4551: THS4551 Support 0 Locked

    259 views
    5 replies
    Latest over 2 years ago
    by Michael Steffes
  • Answered

    INA181: INA181 versus INA181-Q1 0 Locked

    413 views
    1 reply
    Latest over 2 years ago
    by Javier Contreras4
  • Answered

    INA105: INA105 - Application note for Figure 5 0 Locked

    674 views
    2 replies
    Latest over 2 years ago
    by Chris Featherstone
  • Suggested Answer

    OPA2378: What is a replacement 0 Locked

    951 views
    9 replies
    Latest over 2 years ago
    by Marek Lis
  • Suggested Answer

    FX-500 0 Locked

    215 views
    1 reply
    Latest over 2 years ago
    by Noel Fung
  • Suggested Answer

    OPA2227: If my two batches of parts are within the scope of the problem described in this document? 0 Locked

    361 views
    5 replies
    Latest over 2 years ago
    by Chris Featherstone
  • Answered

    LM2904B-Q1: OUTPUT distortion 0 Locked

    357 views
    2 replies
    Latest over 2 years ago
    by Gerasimos Madalvanos
  • Suggested Answer

    AMC1302: AMC1302 TINA waveform distortion 0 Locked

    480 views
    1 reply
    Latest over 2 years ago
    by Alexander Smith
<>