TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS131A02 - Cannot Unlock Device in Synchronous Slave Mode 0 Locked

    546 views
    3 replies
    Latest over 7 years ago
    by Ryan Andrews
  • Suggested Answer

    AFE4400: formula for Pulse Rate / Heart Rate 0 Locked

    678 views
    3 replies
    Latest over 7 years ago
    by Anand Udupa16
  • Suggested Answer

    ADS112C04: not able to use External Vref? and dual read before new measured value 0 Locked

    681 views
    2 replies
    Latest over 7 years ago
    by Jorick de Wit
  • Suggested Answer

    AMC1304M25: Concult the output with the SCLK&DOUT 0 Locked

    533 views
    3 replies
    Latest over 7 years ago
    by Tom Hendrick
  • Answered

    DAC39J82: register adress 0 Locked

    417 views
    1 reply
    Latest over 7 years ago
    by jim s
  • Answered

    CCS/ADS1263: code example 0 Locked

    1948 views
    2 replies
    Latest over 7 years ago
    by Nigel Whitehead18
  • Answered

    DAC8760: DAC8760 Iout 4 ~ 20mA output question 0 Locked

    1626 views
    7 replies
    Latest over 7 years ago
    by Shinichi Inoue
  • Not Answered

    DAC output distorted with different PRF pulses 0 Locked

    1006 views
    8 replies
    Latest over 7 years ago
    by Neeraj Gill
  • Answered

    ADS5407: Replacement for ADS5407 0 Locked

    608 views
    6 replies
    Latest over 7 years ago
    by Mircea Bogdan
  • Answered

    SM73201-ARC-EV: RD-195 GUI ADC SPI data acquisition. 0 Locked

    595 views
    2 replies
    Latest over 7 years ago
    by rjb
  • Answered

    ADS1231: Data is never READY 0 Locked

    1382 views
    6 replies
    Latest over 7 years ago
    by Bob Benjamin
  • Suggested Answer

    ADS1248EVM-PDK: ADS1248EVM-PDK... IDAC0 is not working. IDAC0 Muxed to Ain2 but no current is available 0 Locked

    1267 views
    7 replies
    Latest over 7 years ago
    by Joseph Wu
  • Suggested Answer

    CCS/LMP90100: Bridge sensing and 2-wire RTD 0 Locked

    855 views
    6 replies
    Latest over 7 years ago
    by Joseph Wu
  • Answered

    ADS1298: AVDD power supply 0 Locked

    720 views
    3 replies
    Latest over 7 years ago
    by Ryan Andrews
  • Suggested Answer

    DAC8760: cad file needed 0 Locked

    493 views
    4 replies
    Latest over 7 years ago
    by Kevin Duke
  • Suggested Answer

    ADC128D818: ADC128D818 IN0-7 voltage range if design with internal Vref 0 Locked

    393 views
    3 replies
    Latest over 7 years ago
    by Tom Hendrick
  • Suggested Answer

    CCS/ADS1299EEGFE-PDK: Work With The ADS1299EEG 0 Locked

    649 views
    5 replies
    Latest over 7 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS5282: ADS5282 along with FMC-ADC adapter in spartan 6 device 0 Locked

    931 views
    3 replies
    Latest over 7 years ago
    by dBrock
  • Answered

    ADS1246: Help with ADS1246 and Arduino Uno 0 Locked

    1581 views
    4 replies
    Latest over 7 years ago
    by Andrew Kacmarcik
  • Answered

    DAC7750: Use of the CLR pin from a wdog timer IC. 0 Locked

    342 views
    2 replies
    Latest over 7 years ago
    by John Istad
<>