TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS8504: Temperature drift 0 Locked

    115 views
    8 replies
    Latest 1 month ago
    by Tom Hendrick
  • Suggested Answer

    ADS114S08: Connecting ADS114S08 with PT100 0 Locked

    180 views
    5 replies
    Latest 1 month ago
    by Bryan Lizon86
  • Answered

    AMC60704: AMC60704's VDAC can't be set by the GUI 0 Locked

    275 views
    11 replies
    Latest 1 month ago
    by Katlynne Jones
  • Suggested Answer

    ADS1148: no conversion of ADS1148 0 Locked

    76 views
    3 replies
    Latest 1 month ago
    by Bryan Lizon86
  • Suggested Answer

    ADS1258: Help Needed with ADS1258EVM - Getting Random Data Instead of Expected Voltage on Single-Ended Channel 0 Locked

    91 views
    3 replies
    Latest 1 month ago
    by Keith Nicholas
  • Suggested Answer

    BP-DAC11001EVM: Onboard Vref (REF6250) VCC Conflict (6V Max vs. DAC 8V Min) 0 Locked

    52 views
    1 reply
    Latest 1 month ago
    by Sanjay
  • Suggested Answer

    DAC38J84: clock input standard 0 Locked

    62 views
    4 replies
    Latest 1 month ago
    by Kang Hsia
  • Answered

    AMC1336: CLKIN duty cycle limits 0 Locked

    82 views
    2 replies
    Latest 1 month ago
    by Andreas Fischer
  • Answered

    ADS7066EVM-PDK: Save the data capture automatically 0 Locked

    93 views
    4 replies
    Latest 1 month ago
    by Rick Pease
  • Answered

    ADC3562: Vid:Differential input voltage 0 Locked

    125 views
    4 replies
    Latest 1 month ago
    by Jp_beginnerEnginner
  • Suggested Answer

    ADC12QJ1600EVM: CH_EN functionality in quad channel vs. dual channel mode 0 Locked

    81 views
    1 reply
    Latest 1 month ago
    by Rob Reeder
  • Not Answered

    ADC12DJ5200RF: The data sampled by ADC is degraded. How to optimize it? 0 Locked

    67 views
    1 reply
    Latest 1 month ago
    by Rob Reeder
  • Suggested Answer

    ADC12D1600RB: Select ADC for the application 0 Locked

    56 views
    1 reply
    Latest 1 month ago
    by Rob Reeder
  • Suggested Answer

    ADC3669EVM: Operating mode of the ADC3669 converter 0 Locked

    155 views
    7 replies
    Latest 1 month ago
    by Luke Allen
  • Not Answered

    AFE7950EVM: capturing with a TSW14J56EVM 0 Locked

    57 views
    2 replies
    Latest 1 month ago
    by John Gianvittorio
  • Suggested Answer

    DAC5662: Schematic review 0 Locked

    43 views
    1 reply
    Latest 1 month ago
    by Rob Reeder
  • Answered

    ADS7953: Clarification on analog supply voltage in 2x VREF mode 0 Locked

    60 views
    2 replies
    Latest 1 month ago
    by David Albrecht
  • Suggested Answer

    DAC39RF10EVM: Is it Possible to use the DAC39RF10EVM without a pattern generator? 0 Locked

    62 views
    1 reply
    Latest 1 month ago
    by Rob Reeder
  • Not Answered

    ADC3669EVM: Tswdc155evm 0 Locked

    32 views
    1 reply
    Latest 1 month ago
    by Rob Reeder
  • Answered

    DAC39J82: DAC39J82IAAV +1 Locked

    81 views
    2 replies
    Latest 1 month ago
    by Rob Reeder
<>