Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] DS90UB953-Q1: Latency of DS90UB953-Q1 and DS90UB954-Q1

    Part Number: DS90UB953-Q1 Hi, I'm using a system with a n output of MIPI-CSI2. with one lane in 800Mbps, using the above Serializer and deserializer. The spec only specified to latency of the GPIOs, is it possible to know the latency of both devices…

  • [FAQ] SN65DSI84: No display output with SN65DSI83, SN65DSI84, SN65DSI85

    Part Number: SN65DSI84 Other Parts Discussed in Thread: SN65DSI85 , SN65DSI83 , DSI-TUNER I have implemented the SN65DSI83, SN65DSI84, and SN65DSI85 to bridge DSI video output from my processor to LVDS input on my display. However, the display is just blank…

  • [FAQ] What're the recently released RS-485 transceivers in TI?

    RS-485 Selection Guide RS-485 Hero Device Flyer - MM.pdf select recommended RS-485 transceivers by supply voltage, maximum supports data rate, integrated protections, and other key feature sets. Please go to www.ti.com/rs485 for details.

  • [FAQ] TUSB320: Clarify DFP to Type-C 1.0 DRP incompatibility

    Part Number: TUSB320 Other Parts Discussed in Thread: TUSB322 , TUSB321 , The datasheet indicates "A USB Type-C 1.1 compliant DFP can not connect to a Type-C 1.0 DRP" and "This limitation is a result of a backwards compatibility problem between USB Type…

  • [FAQ] TUSB212: Why does USB 2 (HS) stop working when multiple USB 2 redrivers are enabled?

    Part Number: TUSB212 I have a system where I have implemented USB 2 that uses long traces and cables. To accommodate for the long traces and cables and still pass the USB 2 eye mask compliance test I used two USB 2 redrivers. When both USB 2 redrivers…

  • [FAQ] When do I select a PD controller or CC controller for USB Type-C applications?

    I am transitioning my system from an older USB connector to the USB Type-C connector. However I do not know whether I need a one of TI's Power Delivery (PD) controller or a CC controllers. When should I chose a PD controller or CC controller and what…

  • [FAQ] CAN transceiver SPLIT pin

    Other Parts Discussed in Thread: TCAN1043 What is the function of the SPLIT pin on a CAN transceiver?

  • [FAQ] CAN transceiver power consumption

    Other Parts Discussed in Thread: TCAN1043 How can the power consumption of a CAN transceiver in active operation be calculated?

  • [FAQ] TUSB1044: How to configure a PD controller to configure TUSB1044 and support virtual HPD?

    Part Number: TUSB1044 When using a PD controller to configure a TUSB1044 (Type-C Linear Redriver) over I2C it is best to follow the scheme below for programming the PD in this regard. This scheme also includes support for applications in need of a "virtual…

  • [FAQ] definition of signal conditioner(redriver/repeater/retimer..)

    Dear experts, I want to understand the signal conditioner definition. would you explain what is difference between redriver and repeater and retimer ? Thanks, JH.

View FAQ threads