TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] Interface Protection Guides

    Josh Prushing
    Josh Prushing
    Back to FAQ Home Page Interface Protection Guides Part Recommendation Packaging & Layout Models Transient Standards System/Device Level Design Power Dissipation and Temperature Top Threads …
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] SN75DPHY440SS: Is it okay to swap the polarity and lane order?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: SN75DPHY440SS My customer asked about changing positive signal and negative signal. (i.e. applying positive input to DA0N, negative input to DA0P, positive input to DA1N, negative signal to DA1P, and so on.) Is it okay to use this device…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS280DF810: Can I use a signal conditioning device at a lower data rate than its target application?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Other Parts Discussed in Thread: DS160PR410 , A common question when using a signal conditioning device is can the device support a data rate that is lower than the target data rate. The answer to this is device dependent, but…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Debug procedure if TI TUSB80xx or TUSB40xx hub can not be detected by USB host

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A 1: Check power on reset sequence waveform for 3.3v ,1/1v and GRSTz pin and see if it meets hub power on reset sequence timing 2: Check voltage on USB_VBUS pin and see if the voltage is around 0.5v 3: Check if the crystal is…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TMUXHS4212: When and how to AC coupling the passive MUX?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: TMUXHS4212 When and how do I place the AC coupling capacitors for the passive MUX?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: Does redriver power consumption vary with data rate?

    Evan Su
    Evan Su
    Part Number: DS320PR810 Other Parts Discussed in Thread: DS160PR421 , DS160PR1601 , DS160PR410 , DS160PR810 , DS160PR412 , , DS320PR1601 , DS320PR410 , SN75LVPE5412 , SN75LVPE5421 Applicable to all TI PCIe redrivers for Gen 4: DS160PR410, DS160PR810…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Difference between TUSB804x USB3 hub family

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A Other Parts Discussed in Thread: TUSB8041 , , TUSB8042A , TUSB8043A , TUSB8044A Over the time, TI TUSB804x USB3 hub family has been transitioned from USB3.0 to USB3.1, from TUSB8041 to TUSB8041A/8042A/8043A/8044A. Here is the…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to enable snoop mode with HDMI re-driver/re-timer

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Brief Overview of HDMI PHY: The HDMI physical layer is composed of 4 high-speed lanes, one Display Data Channel (DDC) which operates with I2C signaling, Hot Plug Detect (HPD) for device detection, Consumer Electronic Control …
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS560DF810: Explanation of Crosspoint and Gearbox Modes

    Lucas Wolter
    Lucas Wolter
    Part Number: DS560DF810 Other Parts Discussed in Thread: DS560DF410 , DS560DF810 and DS560DF410 offer a variety of crosspoint and gearbox modes which can be used for 1:2 fanout, channel crossing, and NRZ/PAM4 modulation conversion. In this thread, I will…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR1601: Receiver Detect Reset for x2 SSD Hot Plug Applications

    Nick Peabody
    Nick Peabody
    Part Number: DS320PR1601 Other Parts Discussed in Thread: DS320PR810 In this E2E FAQ, I am going to provide an overview of RX detect with specific information on the RX detect pulse width and frequency, then, I am going to discuss hot plug functionality…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    Firewire bus initialization with TSB81BA3 0 Locked

    1034 views
    4 replies
    Latest over 14 years ago
    by Nicolas Mutz
  • Answered

    TLK1101E related question 0 Locked

    720 views
    2 replies
    Latest over 14 years ago
    by Drew Lundsten
  • Answered

    TUSB3410 0 Locked

    1482 views
    7 replies
    Latest over 14 years ago
    by Roberto Diaz
  • Not Answered

    TUSB3410 Intermittent Connectivity 0 Locked

    300 views
    1 reply
    Latest over 14 years ago
    by Roberto Diaz
  • Answered

    SN75LVDS83/SN75LVDS86 Pair 0 Locked

    500 views
    1 reply
    Latest over 14 years ago
    by DHarmon
  • Answered

    The BER of TLK3101 0 Locked

    310 views
    1 reply
    Latest over 14 years ago
    by Atul Patel
  • Answered

    LOOKING for EVM board 0 Locked

    307 views
    1 reply
    Latest over 14 years ago
    by DHarmon
  • Answered

    ISO7231A output port capacitor 0 Locked

    384 views
    1 reply
    Latest over 14 years ago
    by Thomas Kugelstadt
  • Answered

    PCI 2040 EVM 0 Locked

    460 views
    1 reply
    Latest over 14 years ago
    by DHarmon
  • Answered

    a resolve way about usb3.0 device by TMS320C6A816x. 0 Locked

    438 views
    1 reply
    Latest over 14 years ago
    by DHarmon
  • Answered

    How become usb3.0 video device?(tusb9260) 0 Locked

    307 views
    1 reply
    Latest over 14 years ago
    by DHarmon
  • Answered

    Some questions about TUSB9260 and tms320c6a8168. 0 Locked

    423 views
    3 replies
    Latest over 14 years ago
    by DHarmon
  • Answered

    Tiusb setup in debian 0 Locked

    623 views
    3 replies
    Latest over 14 years ago
    by Roberto Diaz
  • Not Answered

    LVDS signal to Desktop computer/Laptop computer 0 Locked

    1907 views
    3 replies
    Latest over 14 years ago
    by DHarmon
  • Not Answered

    Behav. Simulation Model for TLK3101 0 Locked

    517 views
    4 replies
    Latest over 14 years ago
    by Kent Dahlgren
  • Answered

    XIO2200A device power consumption 0 Locked

    351 views
    2 replies
    Latest over 14 years ago
    by Sankar karuppannan
  • Answered

    Line driver and receiver SN75121 and SN75122 replacement 0 Locked

    630 views
    1 reply
    Latest over 14 years ago
    by Thomas Kugelstadt
  • Answered

    SN65LVDM1677 termination 0 Locked

    492 views
    3 replies
    Latest over 14 years ago
    by Atul Patel
  • Answered

    TPD2S017 bipolarity? 0 Locked

    496 views
    1 reply
    Latest over 14 years ago
    by Dwight
  • Answered

    TUSB1310 with Altera FPGA 0 Locked

    1112 views
    5 replies
    Latest over 14 years ago
    by DHarmon
<>