TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DP83867E: Ethernet PHY SGMII Vdiff Upper and Lower Input Limits

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869 The DP83867 and DP83869 both have the same Vdiff Upper and Lower Input Limits of: 100 mV and 800 mV
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] What capacitance should my ESD diode be?

    Ethan Sempsrott
    Ethan Sempsrott
    Other Parts Discussed in Thread: ESD2CANXL24-Q1 , ESD2CAN24-Q1 , ESD2CANFD24-Q1 , ESD122 What should be considered when selecting a diode with parasitic capacitance?
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83825I: How to adjust the Output Differential Voltage (VOD) of the DP83825I

    David Creger
    David Creger
    4540.DP83825I VOD Adjustment.pptx
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720R-Q1: Why is my SGMII eye measurement distorted?

    Melissa Chang
    Melissa Chang
    Part Number: DP83TG720R-Q1 SGMII signal is high frequency low-voltage differential signal. Both layout design and measurements need to be accurate for good eye diagram capture. Common board design guidelines: 100ohms+/-10% differential traces…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Can an ESD diode experience latch-up?

    Ethan Sempsrott
    Ethan Sempsrott
    Other Parts Discussed in Thread: STRIKE Is there a risk of latch-up with ESD diodes? Should this be taken into design consideration?
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] What is the difference between TLP and 8/20μs clamping voltages on ESD diode datasheets?

    Ethan Sempsrott
    Ethan Sempsrott
    Other Parts Discussed in Thread: ESD321 , STRIKE What is the TLP clamping voltage, and how is it different compared to the 8/20μs clamping voltage? Take the electrical characteristics for ESD321 as an example:
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] LMH0303: How to Tune LMH0303 LMH0307 Cable Fault detection

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH0303 Other Parts Discussed in Thread: LMH0307 , Background: The LMH0307/3 termination fault detection was never designed to be precise; its purpose is to provide an indication when no cable is connected to the output (near end). The…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UB953-Q1: Does this Serializer have failure mode regarding delayed/frozen video transmission?

    Weicheng Li
    Weicheng Li
    Part Number: DS90UB953-Q1 Hi TI expert Can you pls help to confirm if the serializer (DS90UB953)can have Frozen and delayed video output failure modes? If Yes, pls share the safety mechanisms for these failure modes. Thanks Br Weicheng
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] AM6x to DP83867IR: How to read/write register values in DP83867 with addresses above 0x001F?

    Rimika Gupta
    Rimika Gupta
    Part Number: DP83867IR Problem Statement: Hi Expert, How to read/write register values in DP83867 with addresses above 0x001F? Regards
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: How does Strap1 (CLKOUT/LED1) work on DP83826?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E DP83826's Strap1 (CLKOUT/LED1) is an internal PU (Pull-up) strap pin. Strapping this high (either by default or external PU) will enable Odd Nibble Detection in the PHY. Strapping this low will disable Odd Nibble Detection as well…
    • over 2 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    SN65HVD82: Can SN65HVD888 be used instead of SN65HVD82? 0 Locked

    759 views
    3 replies
    Latest over 4 years ago
    by Eric Hackett
  • Suggested Answer

    How to pass data from the AD converter to the DSP and the role of the data processor 0 Locked

    273 views
    4 replies
    Latest over 4 years ago
    by Hiroyuki Kanematu
  • Suggested Answer

    FPC402: Cannot read back register value 0 Locked

    354 views
    1 reply
    Latest over 4 years ago
    by Nasser Mohammadi
  • Answered

    DS160PR412-421EVM: what is the function of jump wires 0 Locked

    292 views
    1 reply
    Latest over 4 years ago
    by Nasser Mohammadi
  • Answered

    DS90UB928Q-Q1: Question about register 0x41(Link Error Count) 0 Locked

    369 views
    3 replies
    Latest over 4 years ago
    by Charley Cai
  • Suggested Answer

    DS92001: how to get the ibis model for DS92001 ? 0 Locked

    283 views
    1 reply
    Latest over 4 years ago
    by David (ASIC) Liu
  • Suggested Answer

    DS92LX1622: tRJIT(Receiver Input Jitter Tolerance) 0 Locked

    306 views
    1 reply
    Latest over 4 years ago
    by Charley Cai
  • Answered

    TPD4E1U06: LAN 2.5G/10G 0 Locked

    308 views
    4 replies
    Latest over 4 years ago
    by GARETH OU
  • Suggested Answer

    DP83848J: How to validate/test DP83848JSQ 0 Locked

    204 views
    5 replies
    Latest over 4 years ago
    by Lysny Woodahl
  • Suggested Answer

    XIO2001: system and speed 0 Locked

    212 views
    1 reply
    Latest over 4 years ago
    by Nasser Mohammadi
  • Not Answered

    TPS65983B: Problem for TPS65983B application tool... 0 Locked

    377 views
    4 replies
    Latest over 4 years ago
    by Raymond Wen
  • Suggested Answer

    XIO2001: Can PCIe_Host config PCI configuration through XIO2001? 0 Locked

    224 views
    1 reply
    Latest over 4 years ago
    by Nasser Mohammadi
  • Suggested Answer

    SN65LVELT22EVM: Similar/compatible evaluation board for SN65LVELT22EVM 0 Locked

    343 views
    1 reply
    Latest over 4 years ago
    by David (ASIC) Liu
  • Answered

    TS3USBA225: Asking for the TS3USBA225 and TS3USB221DRC design review 0 Locked

    364 views
    3 replies
    Latest over 4 years ago
    by Brian Zhou
  • Answered

    TUSB2036: long-term availability 0 Locked

    255 views
    2 replies
    Latest over 4 years ago
    by Jannes Kollien
  • Answered

    TPS25810: Current Limit of VCONN 0 Locked

    351 views
    1 reply
    Latest over 4 years ago
    by Adam Mc Gaffin
  • Suggested Answer

    SN75DP159: Firmware of SN75DP159 0 Locked

    258 views
    1 reply
    Latest over 4 years ago
    by David (ASIC) Liu
  • Suggested Answer

    TPD6S300: Could TPD6s300 replace TPD6s300A. 0 Locked

    361 views
    1 reply
    Latest over 4 years ago
    by Adam Mc Gaffin
  • Suggested Answer

    AM26C31: Power dissipation details 0 Locked

    288 views
    2 replies
    Latest over 4 years ago
    by Eric Schott1
  • Answered

    TCAN4550: TCAN4550 + MSP430 isolation solution 0 Locked

    637 views
    3 replies
    Latest over 4 years ago
    by Eric Schott1
<>