TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS110DF111: How common 10G ethernet specifications fit into a typical application

    Lucas Wolter
    Lucas Wolter
    Part Number: DS110DF111 In this FAQ, I will explain how common 10G ethernet specifications fit into a typical application. The below application diagram comes from the DS110DF111 datasheet. Many 10G ethernet specifications are defined by the IEEE…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83869HM: Bridge Mode Clarification

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83869HM The DP83869HM supports two types of Bridge Modes to translate data between two MAC interface types. The two types are: RGMII-to-SGMII mode SGMII-to-RGMII mode The naming convention implies MAC-to-PHY and the functionality…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    DS90UB960-Q1: FPD Link layout routing layer and refernece layer questions 0 Locked

    344 views
    3 replies
    Latest over 5 years ago
    by Steven(Shenzhen) Shi
  • Answered

    DS90UB954-Q1: Design help 0 Locked

    611 views
    2 replies
    Latest over 5 years ago
    by FRANK1
  • Answered

    DP83825I: Where is pin TX_ER on this PHY? 0 Locked

    214 views
    1 reply
    Latest over 5 years ago
    by Justin Lazaruk
  • Suggested Answer

    TUSB1002A: Pls help check the sch? 0 Locked

    294 views
    6 replies
    Latest over 5 years ago
    by Brian Zhou
  • Not Answered

    DS90UB954-Q1: The last 3 lines of sensor0/1 captures are interchanged when use 954/954 0 Locked

    576 views
    4 replies
    Latest over 5 years ago
    by Mandeep S
  • Answered

    TUSB8042A: 1:4 Type C hub 0 Locked

    506 views
    8 replies
    Latest over 5 years ago
    by Brian Zhou
  • Suggested Answer

    DS90UB954-Q1: How to prevent loss of LOCK 0 Locked

    390 views
    1 reply
    Latest over 5 years ago
    by Jiashow Ho
  • Suggested Answer

    TCA9800: TCA9800 B side pull up resistor 0 Locked

    429 views
    1 reply
    Latest over 5 years ago
    by Miguel Robertson
  • Suggested Answer

    HD3SS215: Support HDMI 2.0? 0 Locked

    352 views
    1 reply
    Latest over 5 years ago
    by David (ASIC) Liu
  • Suggested Answer

    TMUXHS4212: Will it be back-powered? 0 Locked

    214 views
    1 reply
    Latest over 5 years ago
    by Brian Zhou
  • Suggested Answer

    TCA9539-Q1: Confirm if after setting a GPIO pin to output, it will return to floating after power is turned off 0 Locked

    315 views
    1 reply
    Latest over 5 years ago
    by Miguel Robertson
  • Not Answered

    TUSB8044A: [Driver support] TUSB8044A ? 0 Locked

    555 views
    3 replies
    Latest over 5 years ago
    by JMMN
  • Answered

    TCAN4550EVM: CANSLNT Error Flag is Set, Not using Wake or Sleep Mode, RX/TX Pkts OK 0 Locked

    528 views
    6 replies
    Latest over 5 years ago
    by Greg Holdren
  • Answered

    DS90UB940-Q1: 940 How to set it to output the YUYV format image 0 Locked

    311 views
    4 replies
    Latest over 5 years ago
    by Michael.Walker
  • Suggested Answer

    SN65HVDA1040A-Q1: CAN Driver TVS diode maximum Clamping voltage and Junction Capacitance 0 Locked

    661 views
    2 replies
    Latest over 5 years ago
    by Arvind Munde
  • Suggested Answer

    TCAN1043-Q1: About TCAN1043 application in the datasheet 0 Locked

    1048 views
    1 reply
    Latest over 5 years ago
    by Eric Hackett
  • Suggested Answer

    DS90UH947-Q1: Cable requirement for 947/948 0 Locked

    331 views
    1 reply
    Latest over 5 years ago
    by Bryan Kahler
  • Answered

    HDMI to DP converter 0 Locked

    259 views
    1 reply
    Latest over 5 years ago
    by David (ASIC) Liu
  • Suggested Answer

    PCI Level Translator 0 Locked

    616 views
    1 reply
    Latest over 5 years ago
    by ShreyasRao
  • Answered

    PCA9545A: Enable all port in same time 0 Locked

    226 views
    3 replies
    Latest over 5 years ago
    by Miguel Robertson
<>