TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS125DF111: How to capture a full eye opening measurement using SMBus registers

    Lucas Wolter
    Lucas Wolter
    Part Number: DS125DF111 Other Parts Discussed in Thread: DS110DF111 , , DS100DF410 , DS110DF410 , DS125DF410 Tool/software: In this FAQ, I will cover the SMBus register sequence to capture a full eye opening measurement. This FAQ applies to the following…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: Using EyeScan to Optimize CTLE Setting on Your PCIe Redriver

    Nick Peabody
    Nick Peabody
    Part Number: DS320PR810 Tool/software: Hi All, Texas Instruments uses PCIe redrivers to perform signal conditioning on medium to upper medium loss systems. The redriver is effective in a wide variety of systems with losses ranging from -36dB to -56dB…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP++ & Dual Mode Implementation using a DP redriver

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP2004 Tool/software: What is Dual Mode Dual mode or DP++ allows for a DP source to output a HDMI signal to a sink without using an active protocol converter. The DP source must be DP++ capable for dual mode operation. The key considerations…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: How should PCIe redriver PD pins be configured?

    Evan Su
    Evan Su
    Part Number: DS320PR810 Tool/software: TI PCIe Gen 5/Gen 4 redrivers have powerdown (PD or PWDN) pins. How should I configure them, and why does TI suggest connecting them to inverted PERST# or PRSNT#?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] SN65DPHY440SS: What is the design constraint for DPHY440 lane 0 when using in a MIPI CSI design?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: SN65DPHY440SS Other Parts Discussed in Thread: SN75DPHY440SS Tool/software: I'm utilizing the SN75DPHY440SS in 4 lane configuration with default configuration parameters, sourced by a CSI-2 source. Lanes 1, 2, and 3 are correctly driven and…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1142: How to properly connect the TUSB1142 FLIP pin to the TPS2583xA-Q1 CC controller

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: TUSB1142 Other Parts Discussed in Thread: TPS25820 , Tool/software: The TUSB1142 design uses the Flip signal from a TPS25820 to switch the SuperSpeed signals from a USB Type C connector. We are not able to get SuperSpeed to work at all.
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS280DF810: Why is 25G/28G Retimer PRBS Generator Not Working?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Other Parts Discussed in Thread: DS250DF410 Tool/software: Introduction: One common debug question when using TI's 25G/28G is why is the PRBS generator not working? This FAQ will review the key criteria for the retimer PRBS generator…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB211A: Why does the USB 2.0 redriver not appear to work when taking eye-diagrams?

    Undrea Fields
    Undrea Fields
    Part Number: TUSB211A Tool/software: In order to perform eye-diagram testing, the TUSB211A and other USB 2.0 redrivers must first detect the scope termination after power on or reset. Once termination has been detected, then the redriver will enable the…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS280DF810: Which 25/28G Retimer Should I Select?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Other Parts Discussed in Thread: DS250DF210 , DS250DF230 , DS250DF410 , DS250DF810 , Tool/software: TI has several retimers in its 25/28G retimer product family. This FAQ breaks down some of the key differences between TI's 25…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS280DF810: How can I calculate estimated signal conditioner power consumption?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Tool/software: When implementing a signal conditioning device in a system, one design consideration is the device power consumption. In order to address this design consideration, it's valuable to understand how to calculate the…
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    DP83867IS: Confirming if a Link has been Established 0 Locked

    211 views
    1 reply
    Latest over 2 years ago
    by Gerome Cacho
  • Not Answered

    TUSB2036: TUSB2036 + TPS2033B only momentarily powering USB devices, not showing up as a device 0 Locked

    315 views
    3 replies
    Latest over 2 years ago
    by David (ASIC) Liu
  • Answered

    SN65DP159: SN65DP159RGZ REview 0 Locked

    247 views
    4 replies
    Latest over 2 years ago
    by John DeCesare
  • Suggested Answer

    SN75176B: difference between SN75176A and SN75176B 0 Locked

    844 views
    1 reply
    Latest over 2 years ago
    by Parker Dodson
  • Not Answered

    TUSB8040A1: Looking for TUSB8040A1RKMR Alternative Option 0 Locked

    623 views
    4 replies
    Latest over 2 years ago
    by Brian Zhou
  • Answered

    DP83848J: DP83848J-Communication Issue between PHY IC and RJ 45 Jack 0 Locked

    589 views
    6 replies
    Latest over 2 years ago
    by Gokul Koraganji
  • Suggested Answer

    DS90UB953-Q1: DS90UB953-Q1 and Analog launchPAD 0 Locked

    258 views
    3 replies
    Latest over 2 years ago
    by Hamzeh Jaradat
  • Answered

    DP83867E: Reg 0x0025 by Default is not RW 0 Locked

    200 views
    1 reply
    Latest over 2 years ago
    by jmbats
  • Answered

    DS90UB953-Q1: Questions about FPD-LINK protocol 0 Locked

    344 views
    2 replies
    Latest over 2 years ago
    by Ohad Bonneh
  • Answered

    DS280BR820: Request for updating CTLE or FIR settings of DS280BR820 via I2C 0 Locked

    319 views
    4 replies
    Latest over 2 years ago
    by Shoo Saga
  • Answered

    USB-C Charger Design Requires PD or CC controller? 0 Locked

    300 views
    4 replies
    Latest over 2 years ago
    by Bob Ma
  • Suggested Answer

    DS90CF386: DS90CF386_C385A_setup_time_Value 0 Locked

    401 views
    5 replies
    Latest over 2 years ago
    by Logan Cummins
  • Suggested Answer

    PCA9306: VREF1 and EN configuration 0 Locked

    279 views
    2 replies
    Latest over 2 years ago
    by Danny Bacic
  • Answered

    DP83822H: Life Cycle Information of DP83822HFRHBR 0 Locked

    295 views
    2 replies
    Latest over 2 years ago
    by Pascal Turcotte
  • Answered

    DP83848K: Rise time requirement for VCC 0 Locked

    192 views
    1 reply
    Latest over 2 years ago
    by Gerome Cacho
  • Answered

    DP83867IS: Placing magnetics on the different side of PHY 0 Locked

    279 views
    1 reply
    Latest over 2 years ago
    by Gerome Cacho
  • Answered

    TUSB214-Q1: DC BOOST tolerance 0 Locked

    338 views
    1 reply
    Latest over 2 years ago
    by Ryan Kitto
  • Discussion

    TPD4E001-Q1: Confusing electrical ratings on datasheet Locked

    294 views
    1 reply
    Latest over 2 years ago
    by Sebastian Muriel
  • Answered

    TUSB212: En sequencing 0 Locked

    217 views
    2 replies
    Latest over 2 years ago
    by Ryan Kitto
  • Suggested Answer

    DS90UH947-Q1: PCLK detection (by using register) 0 Locked

    543 views
    10 replies
    Latest over 2 years ago
    by Josh Baik
<>