Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] IxC

    FAQ: Logic and Voltage Translation > IxC (CTRL + F) or (CMD + F) to search key words on this page! Level Translation: [FAQ] How do the LSF translators work? [ FAQ] What is PassFET Hangtime? Buffers: [FAQ] What is a buffered LOW?…

  • [FAQ] DP83826E: DP83826E: How do I determine the MSE/SNR levels using DP83826?

    Part Number: DP83826E Tool/software: MSE/SNR can be determined via Reg 0x218. Please note that this is an extended register and needs 4-step extended register access to read appropriate values. Once the hex value is obtained, convert to decimal…

  • [FAQ] DS320PR810: Can PCIe redriver equalization be bypassed or turned off?

    Part Number: DS320PR810 Other Parts Discussed in Thread: SN75LVPE5412 , Tool/software: Could I disable the equalization of a TI PCIe redriver by setting the EQ index to 0?

  • [FAQ] DS320PR810: What happens if redrivers are cascaded?

    Part Number: DS320PR810 Tool/software: Is cascading redrivers (placing multiple redrivers between root complex and endpoint, one after another) a valid method for extending the reach of a PCIe link beyond what one redriver can handle?

  • [FAQ] DP83867E: 1000Base-T Ethernet Compliance Register Script

    Part Number: DP83867E Tool/software: Ethernet compliance testing is the process of verifying that Ethernet devices and systems adhere to established industry standards and protocols. The current Rev C of SNLA239C provides a script that excludes essential…

  • [FAQ] DS125BR111: EQ boost and gain curves

    Part Number: DS125BR111 Other Parts Discussed in Thread: DS100BR111 , EQ BOOST settings are the same as the CTLE settings. I am going to give a more concrete definition of the CTLE gain curves. Above are the CTLE gain curves for the DS100BR111. If…

  • [FAQ] Do PCIe redrivers support polarity inversion of differential channels?

    Part Number: DS320PR410 Do PCIe redrivers support polarity inversion of differential channels? How can this affect the schematic and layout of my PCIe redriver?

  • [FAQ] DS110DF111: How common 10G ethernet specifications fit into a typical application

    Part Number: DS110DF111 In this FAQ, I will explain how common 10G ethernet specifications fit into a typical application. The below application diagram comes from the DS110DF111 datasheet. Many 10G ethernet specifications are defined by the IEEE…

  • [FAQ] DP83869HM: Bridge Mode Clarification

    Part Number: DP83869HM The DP83869HM supports two types of Bridge Modes to translate data between two MAC interface types. The two types are: RGMII-to-SGMII mode SGMII-to-RGMII mode The naming convention implies MAC-to-PHY and the functionality…

  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…

View FAQ threads