TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to read and write Ethernet PHY registers using a Linux terminal?

    David Creger
    David Creger
    There are several different tools available in a Linux environment to read and write registers on a TI PHY. Several of these options are listed below. MII read: This is the only command which can and must be used in U-boot. Stop the autoboot process…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: How to disable 25MHz clock on clkout pin?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TC812S-Q1 For DP83TC812S/R and DP83TC814-Q1 if clkout pin is not being used to provide a clock signal to another component, then it is recommended to shut down this clock output and reduce its impact on EM emissions. Clkout's output…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Which conformal coating is recommended for Ethernet PHY products?

    Vikram Sharma
    Vikram Sharma
    TI does not have a recommendation for any specific conformal coat or underfill product. In some temperature ranges these materials can be detrimental if the conformal coating or underfill product has a mismatched CTE vs. solder joint (Z axis). This…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: How to test the link-quality using DP83867's BIST and status registers?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867IR DP83867 PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These parameters…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: How to check throughput without depending upon MAC?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TD510E DP83TD510E PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How do I choose magnetics for my industrial PHY?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E There are 5 key parameters to look out for when selecting magnetics: Magnetic type (specifically for integrated RJ-45/Magnetic component) Can the recommended MDI configuration still be met with this component? Turns…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TLK2711-SP: Eye Mask Recommendations

    Drew Miller1
    Drew Miller1
    Part Number: TLK2711-SP There have been some questions regarding the TLK2711-SP eye mask related to the following E2E thread, so I am hoping to clarify them in this post. TLK2711-SP: Is there an EYE diagram mask definition available? - Space & High…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH941AS-Q1: How to configure FPD-Link III 94x audio

    Ryan Fleetham
    Ryan Fleetham
    Part Number: DS90UH941AS-Q1 How do I configure audio for FPD-Link III 94x devices?
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: In enhanced mode, how does DP83826 strapping work?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E When configuring DP83826 in Enhanced Mode, please consult the following flowchart to understand how the different strap pins configure the PHY into various modes.
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: How to read or write registers in extended register space of Ethernet PHY?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TG720S-Q1 write procedure for MMD "1F" registers: write reg<000D> = 0x001F write reg<000E> = <address> write reg<000D> = 0x401F write reg<000E> = <value> read procedure for MMD "1F" registers: write reg<000D> = 0x001F …
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    DS90UB962-Q1: how to discard incomplete frames via setting PORT_CONFIG2 and PORT_PASS_CTL 0 Locked

    972 views
    15 replies
    Latest over 3 years ago
    by Justin Phan
  • Answered

    load switch suggestions: Interface product for momentary unpowered circuit 0 Locked

    407 views
    4 replies
    Latest over 3 years ago
    by Clemens Ladisch
  • Suggested Answer

    SN65DSI83-Q1: Driver Support 0 Locked

    719 views
    2 replies
    Latest over 3 years ago
    by Zach Dryer
  • Suggested Answer

    SN65DSI83-Q1: Looking for MIPI to Fiber 0 Locked

    820 views
    2 replies
    Latest over 3 years ago
    by Zach Dryer
  • Answered

    TUSB8043A: USB3 pin swap 0 Locked

    172 views
    2 replies
    Latest over 3 years ago
    by Dominik Schwarz
  • Not Answered

    TUSB1310A: TUSB1310A 0 Locked

    337 views
    1 reply
    Latest over 3 years ago
    by Brian Zhou
  • Answered

    DS90UB953-Q1: can 953 support 8MP/30fps camera? 0 Locked

    519 views
    1 reply
    Latest over 3 years ago
    by Darrah Merillat
  • Suggested Answer

    DS90UH948-Q1: Deserialize a signal from the DS90UB949 0 Locked

    215 views
    1 reply
    Latest over 3 years ago
    by Hamzeh Jaradat
  • Suggested Answer

    DS90CF386: Did DS90CF386 support a format 1280*720p@60hz? 0 Locked

    470 views
    5 replies
    Latest over 3 years ago
    by Josh Baik
  • Suggested Answer

    API for Microsoft Dynamcis D365FO available? 0 Locked

    147 views
    1 reply
    Latest over 3 years ago
    by Paul King
  • Answered

    TCA4307: SDAI / SDAO data mismatch 0 Locked

    376 views
    4 replies
    Latest over 3 years ago
    by Masahiko Takeuchi
  • Answered

    DS90UB960-Q1: Suporting RAW8 0 Locked

    269 views
    6 replies
    Latest over 3 years ago
    by user4779049
  • Answered

    THVD1451: isolation with pulse transformer 0 Locked

    492 views
    2 replies
    Latest over 3 years ago
    by Shinichi Inoue
  • Suggested Answer

    TCA9517: Recommended pull-up resistor value in HDMI application 0 Locked

    774 views
    10 replies
    Latest over 3 years ago
    by BOBBY
  • Suggested Answer

    DS16F95QML: DS16F95QML RO Voltage Range confirmation 0 Locked

    248 views
    1 reply
    Latest over 3 years ago
    by Parker Dodson
  • Suggested Answer

    TLIN1021A-Q1: Specification of INH 0 Locked

    304 views
    1 reply
    Latest over 3 years ago
    by Danny Bacic
  • Suggested Answer

    DS90UB954-Q1: DS90UB954-Q1 registers setting 0 Locked

    221 views
    1 reply
    Latest over 3 years ago
    by Hamzeh Jaradat
  • Not Answered

    DS90UB960-Q1: DS90UB960-Q1EVM: Frame sync question 0 Locked

    278 views
    3 replies
    Latest over 3 years ago
    by Hamzeh Jaradat
  • Answered

    DS90UH948-Q1: Adjusting LVDS drive strength 0 Locked

    214 views
    4 replies
    Latest over 3 years ago
    by Hamzeh Jaradat
  • Suggested Answer

    DS90UB941AS-Q1: Options 0 Locked

    238 views
    3 replies
    Latest over 3 years ago
    by Ben Dattilo
<>