TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197752 Discussions
  • Suggested Answer

    DDR collision problem 0 Locked

    1012 views
    5 replies
    Latest over 9 years ago
    by woodyiy
  • Answered

    uart issue 0 Locked

    585 views
    2 replies
    Latest over 9 years ago
    by ToddMullanix
  • Answered

    AM335x ISDK v2.1.0.1 PROFINET slave packet loss 0 Locked

    2657 views
    19 replies
    Latest over 9 years ago
    by RY9983
  • Answered

    How to test usb_dev_bulk from Linux OS 0 Locked

    921 views
    1 reply
    Latest over 9 years ago
    by Lalindra Jayatilleke
  • Answered

    AM437X IDK: Problem with configuration of user button hardware interrupt. 0 Locked

    855 views
    4 replies
    Latest over 9 years ago
    by Jacek Jawski
  • Not Answered

    BT.656 Camera connected to DM3730 de not work 0 Locked

    1471 views
    3 replies
    Latest over 9 years ago
    by dinesh singh kutiyal
  • Answered

    CC2650 How to wakeup module weekly 0 Locked

    3450 views
    6 replies
    Latest over 9 years ago
    by Robert Chen
  • Answered

    Clock source for internal DSP and external timer 0 Locked

    335 views
    4 replies
    Latest over 9 years ago
    by Ganapathi Dhandapani95
  • Answered

    Are individual ferrites on each VDDSHV group really necessary? 0 Locked

    374 views
    2 replies
    Latest over 9 years ago
    by Josh Heiner
  • Answered

    Linux SDK Beaglebone Black + Yocto + Custom Display 0 Locked

    1112 views
    3 replies
    Latest over 9 years ago
    by Kemal R. Shakir
  • Answered

    Where to find the detailed pinmux for peripherals in IDK AM437X? 0 Locked

    598 views
    3 replies
    Latest over 9 years ago
    by Jacek Jawski
  • Answered

    Beaglebone black : frequency meter 0 Locked

    791 views
    3 replies
    Latest over 9 years ago
    by Biser Gatchev-XID
  • Answered

    AM3354ZCZ/600Mhz powered with TPS650250 0 Locked

    362 views
    2 replies
    Latest over 9 years ago
    by Barna Csenteri
  • Not Answered

    YUV range supported on MJPEG Encoder 0 Locked

    573 views
    3 replies
    Latest over 9 years ago
    by Margarita Gashova
  • Answered

    AM572x: How to treat RTC pins when RTC function is unused 0 Locked

    376 views
    2 replies
    Latest over 9 years ago
    by Wolfram Stumpf
  • Not Answered

    Need help with multich_encode_decode usecase DM8148 0 Locked

    363 views
    2 replies
    Latest over 9 years ago
    by user4480700
  • Suggested Answer

    Beaglebone Black with custom Display 10.1'' 1280x800 0 Locked

    1081 views
    1 reply
    Latest over 9 years ago
    by Kemal R. Shakir
  • Suggested Answer

    BE0n,BE1n(Byte enable) signals specification of AM335x ? 0 Locked

    3334 views
    16 replies
    Latest over 9 years ago
    by shigehiro tsuda
  • Answered

    L138/C6748 LCDK: Which Starterware? 0 Locked

    523 views
    2 replies
    Latest over 9 years ago
    by dspRookie
  • Answered

    Profibus 0 Locked

    1373 views
    11 replies
    Latest over 9 years ago
    by Rohan Eric
<>