Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Hello,
Here is a quick look at live demonstrations on TI's Edge AI Platform shown at Electronica 2022 .
Featured Edge AI Applications in Real world enabled on TI Processors at Electronica 2022
Robotics & Automation…
Part Number: TDA4VM Other Parts Discussed in Thread: DRA821
The DDR is configured by R5 SPL/SBL. Is there a way to check the frequency of DDR from Linux at runtime?
I’m working on customer board porting, and want to know how to modify QSPI/OSPI flash layout for SPL/u-boot booting from QSPI/OSPI with TI AM64x Linux SDK.
eMMC flash and boot work as expected on AM62x-SK E2 board from Power-On-Reset (POR), but an issue as listed below is observed on AM62x-SK E2. The Issue observed After successful eMMC boot from cold POR, WARM RESET options as listed below doesn’t re-boot…
Part Number: AM625
Hi, my customer has a question about using an output from the TPS6593 PMIC + a FET to control ON/OFF for 1.8V VPP on the processor? They are trying to see if they can get by without using a dedicated LDO for 1.8V VPP.
Part Number: TDA4VM Other Parts Discussed in Thread: DRA829 , , DRA821 , TDA4VH
Hi
I want to use the new Native Linux Driver introduces in PSDK Linux 8.4. How do I start?
Part Number: AM625
Hello,
I am using the AM62 SK eva kit with PROCESSOR-SDK-LINUX-AM62 08.04.01.03
As I understand MAIN_UART1 and WKUP_UART0 is used by the DM and TIFS firmware.
This is the configuration
MAIN_UART0: Used for Linux and U-Boot…
