TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] UART Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page UART Protection Highlights: Lower speed serial data transfer interface Operating lines: GND, ±TX, ±RX Datalines (±Tx, ±Rx) Operating voltage: 3.3V, recommended Vbr > 3.6V Data rates up to 5Mbps TI…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] RS232 and RS485 Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page RS232 and RS485 Protection Highlights: RS-485 – Industry standard protocol for data transfer from sensors, etc. Drive capability of minimum 32 unit loads (UL, 12kΩ) Uses two signal lines A & B which must be balanced…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    DS90UH948-Q1: Several signal related issues confirmed. 0 Locked

    366 views
    5 replies
    Latest over 1 year ago
    by Jack Scherlag
  • Suggested Answer

    DS100BR111: Redriver for 10G KX ad KR. 0 Locked

    395 views
    3 replies
    Latest over 1 year ago
    by Drew Miller1
  • Answered

    DP83867ERGZ-S-EVM: About wiring of MDI terminal and RJ45 terminal 0 Locked

    545 views
    4 replies
    Latest over 1 year ago
    by TOSHIKAZU HORI
  • Not Answered

    TCAN1145-Q1: TCAN1145-Q1 related issues 0 Locked

    250 views
    3 replies
    Latest over 1 year ago
    by Sean Guo
  • Not Answered

    TCAN1145-Q1: TCAN1145-Q1 Application Problem 0 Locked

    231 views
    1 reply
    Latest over 1 year ago
    by Sean Guo
  • Answered

    DP83826I: Voltage Mode Center Tap Capacitors 0 Locked

    2167 views
    5 replies
    Latest over 1 year ago
    by Greg
  • Not Answered

    [FAQ] What is a buffered LOW? 0 Locked

    994 views
    0 replies
    Started over 1 year ago
    by Tyler Townsend
  • Suggested Answer

    TUSB211A: Question about TUSB211A 0 Locked

    289 views
    2 replies
    Latest over 1 year ago
    by Ryan Kitto
  • Suggested Answer

    TUSB9261: Failed to Load the Firmware 0 Locked

    589 views
    15 replies
    Latest over 1 year ago
    by Ryan Kitto
  • Suggested Answer

    DP83822I: Looking for 10/100Base-TX PHY 0 Locked

    367 views
    7 replies
    Latest over 1 year ago
    by Gerome Cacho
  • Suggested Answer

    TCAN1057AV-Q1: TJA1051 schematic components change 0 Locked

    323 views
    1 reply
    Latest over 1 year ago
    by Sean Guo
  • Not Answered

    TLIN1431-Q1: Need more information on WAKE Pin behavior 0 Locked

    224 views
    2 replies
    Latest over 1 year ago
    by Danny Bacic
  • Not Answered

    SN65HVD230: Device Failure 0 Locked

    399 views
    5 replies
    Latest over 1 year ago
    by Sean Guo
  • Answered

    DP83822IF: Application Inquries 0 Locked

    482 views
    7 replies
    Latest over 1 year ago
    by Evan Mayhew
  • Answered

    DS90UB948-Q1: After setting the gpio2 output pwm to the backlight chip, the 20v output of the backlight chip (LP8864SQRHBRQ1) disappears, the backlight flashes momentarily, and then the problem is not bright 0 Locked

    412 views
    8 replies
    Latest over 1 year ago
    by Zhiqian Wu
  • Answered

    SN65DSI83: Is there any concern about thermal? 0 Locked

    260 views
    2 replies
    Latest over 1 year ago
    by David (ASIC) Liu
  • Suggested Answer

    TMUXHS4412: Does TMUXHS4412IRUAR support PCIE Peer to Peer mode and NTB(Non-Transparent Bridge) mode? 0 Locked

    293 views
    3 replies
    Latest over 1 year ago
    by Brian Zhou
  • Suggested Answer

    SN65DP141: Request EQ curve for eye diagram fine tune 0 Locked

    327 views
    2 replies
    Latest over 1 year ago
    by David (ASIC) Liu
  • Answered

    TCAN4550-Q1: Multiple TCAN4550-Q1 connected to single SPI 0 Locked

    283 views
    1 reply
    Latest over 1 year ago
    by Jonathan Nerger
  • Suggested Answer

    TCA9535: Application issues of chips 0 Locked

    312 views
    5 replies
    Latest over 1 year ago
    by Tyler Townsend
<>