TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] SN75DPHY440SS: Is it okay to swap the polarity and lane order?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: SN75DPHY440SS My customer asked about changing positive signal and negative signal. (i.e. applying positive input to DA0N, negative input to DA0P, positive input to DA1N, negative signal to DA1P, and so on.) Is it okay to use this device…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS280DF810: Can I use a signal conditioning device at a lower data rate than its target application?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Other Parts Discussed in Thread: DS160PR410 , A common question when using a signal conditioning device is can the device support a data rate that is lower than the target data rate. The answer to this is device dependent, but…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Debug procedure if TI TUSB80xx or TUSB40xx hub can not be detected by USB host

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A 1: Check power on reset sequence waveform for 3.3v ,1/1v and GRSTz pin and see if it meets hub power on reset sequence timing 2: Check voltage on USB_VBUS pin and see if the voltage is around 0.5v 3: Check if the crystal is…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TMUXHS4212: When and how to AC coupling the passive MUX?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: TMUXHS4212 When and how do I place the AC coupling capacitors for the passive MUX?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: Does redriver power consumption vary with data rate?

    Evan Su
    Evan Su
    Part Number: DS320PR810 Other Parts Discussed in Thread: DS160PR421 , DS160PR1601 , DS160PR410 , DS160PR810 , DS160PR412 , , DS320PR1601 , DS320PR410 , SN75LVPE5412 , SN75LVPE5421 Applicable to all TI PCIe redrivers for Gen 4: DS160PR410, DS160PR810…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Difference between TUSB804x USB3 hub family

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A Other Parts Discussed in Thread: TUSB8041 , , TUSB8042A , TUSB8043A , TUSB8044A Over the time, TI TUSB804x USB3 hub family has been transitioned from USB3.0 to USB3.1, from TUSB8041 to TUSB8041A/8042A/8043A/8044A. Here is the…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to enable snoop mode with HDMI re-driver/re-timer

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Brief Overview of HDMI PHY: The HDMI physical layer is composed of 4 high-speed lanes, one Display Data Channel (DDC) which operates with I2C signaling, Hot Plug Detect (HPD) for device detection, Consumer Electronic Control …
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS560DF810: Explanation of Crosspoint and Gearbox Modes

    Lucas Wolter
    Lucas Wolter
    Part Number: DS560DF810 Other Parts Discussed in Thread: DS560DF410 , DS560DF810 and DS560DF410 offer a variety of crosspoint and gearbox modes which can be used for 1:2 fanout, channel crossing, and NRZ/PAM4 modulation conversion. In this thread, I will…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR1601: Receiver Detect Reset for x2 SSD Hot Plug Applications

    Nick Peabody
    Nick Peabody
    Part Number: DS320PR1601 Other Parts Discussed in Thread: DS320PR810 In this E2E FAQ, I am going to provide an overview of RX detect with specific information on the RX detect pulse width and frequency, then, I am going to discuss hot plug functionality…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Linear vs. Limited Mode in Redrivers

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 Linear Mode: In linear mode the data received from the GPU’s transmitter is the data that will be sent out of the TX end of the redriver. This means that the GPU’s voltage swing, pre-emphasis…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    DP159 Resolution 0 Locked

    1459 views
    7 replies
    Latest over 9 years ago
    by Marco Hsieh
  • Answered

    Higher data rate application of HDMI TMDS retimer 0 Locked

    665 views
    2 replies
    Latest over 9 years ago
    by JH Huang
  • Answered

    TMDS181 Handling for Unused SPDIF_IN and ARC_OUT 0 Locked

    788 views
    2 replies
    Latest over 9 years ago
    by Sadanori Kato
  • Answered

    TMDS181 I2C Bus Control 0 Locked

    789 views
    2 replies
    Latest over 9 years ago
    by Sadanori Kato
  • Answered

    SN65DSI84 Jitter Constraint Condition for DSI_CLK 0 Locked

    677 views
    2 replies
    Latest over 9 years ago
    by Sadanori Kato
  • Not Answered

    questions about the UART FIFO 0 Locked

    339 views
    0 replies
    Started over 9 years ago
    by Peter Chen(ICP_FAE)
  • Not Answered

    TPD2S017 OPERATING VOLTAGE 0 Locked

    1173 views
    8 replies
    Latest over 9 years ago
    by Alex Kupchik66
  • Not Answered

    TCA6424A with RESET pin left floating 0 Locked

    646 views
    2 replies
    Latest over 9 years ago
    by ShreyasRao
  • Answered

    TUSB1210 Vbat recommended voltage 0 Locked

    1450 views
    7 replies
    Latest over 9 years ago
    by Gerardo
  • Not Answered

    at OMAP35xx there is an option to boot as a USB device. We found out that there may be some initialization code that could be interesting for us. 0 Locked

    300 views
    1 reply
    Latest over 9 years ago
    by Micha Yardeny
  • Answered

    TUSB3410 USB I2C Header Generator Utility 0 Locked

    936 views
    2 replies
    Latest over 9 years ago
    by Kshitij Gupta
  • Answered

    SN65DSI84 throughput 0 Locked

    722 views
    2 replies
    Latest over 9 years ago
    by NAOKI AOYAMA
  • Not Answered

    Survey TI have Dual Channel ACTIVE EMI & ESD Suppressor for Ethernet Applications? 0 Locked

    741 views
    3 replies
    Latest over 9 years ago
    by Kuo Nowal
  • Discussion

    Driver IC for Inorganic Electro-Luminescence Locked

    918 views
    2 replies
    Latest over 9 years ago
    by Ryuji
  • Not Answered

    SN75DP130 for 4k2k issue 0 Locked

    851 views
    2 replies
    Latest over 9 years ago
    by Kai Hsiao
  • Answered

    HD3SS215 decoupling capacitor 0 Locked

    794 views
    2 replies
    Latest over 9 years ago
    by NAOKI AOYAMA
  • Answered

    selection tool for RS485 transceiver 0 Locked

    1025 views
    2 replies
    Latest over 9 years ago
    by K.Yaita
  • Not Answered

    Help debugging SN75LVDS83 + TI DaVinci 0 Locked

    2412 views
    2 replies
    Latest over 9 years ago
    by Giovanni Peroni
  • Answered

    TCA9517 / Use with 3.3V bus master with 5V and 3.3V slave 0 Locked

    1736 views
    3 replies
    Latest over 9 years ago
    by Siby James
  • Not Answered

    DS90UB913A DS90UB914A Yield Issues 0 Locked

    3008 views
    11 replies
    Latest over 9 years ago
    by terpaccount
<>