Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] How do I debug a TI USB Hubs when downstream ports are non-operational?

    Other Parts Discussed in Thread: TUSB8044 , TUSB8041A , TUSB8043 , TUSB8042 , TUSB4020BI , TUSB8020B , TUSB8041 , TUSB4041I I have implemented a USB Hub with four USB 3.1 Gen / USB 2.0 ports using TUSB8044 however the downstream ports don’t work when…

  • [FAQ] How to Enable DSxxxDFxxx to Lock to Any Data Rate within VCO Range

    Part Number: DS280DF810 Other Parts Discussed in Thread: SIGCONARCHITECT In this example, we use a non-standard data rate - for example 24.33Gbps - and configure register settings to lock to this data rate. Note: Data rate MUST be within the device…

  • [FAQ] DS280DF810: What are register settings to enable prbs generator and checker using a simple divide by 2, 4, or 8 clock

    Part Number: DS280DF810 Using DS280DFxxx or DS250DFxxx we can use a simple divide by 2, 4, or 8 of the data rate clock to generate different prbs pattern at different data rates up to 28Gbps. What are the register settings to make this happen?

  • [FAQ] DS250DF410: How to setup PRBS pattern generation/checker using divide by 2, 4, or 8 clock

    Part Number: DS250DF410 Other Parts Discussed in Thread: SIGCONARCHITECT Using a simple clock, DS250DFxxx and DS280DFxxx can generate different prbs patterns at different data rate up to 28Gbps. To make it very simple, SigconArchitect can be used to achieve…

  • [FAQ] PCA9306: Voltage levels translation

    Part Number: PCA9306 To allow proper translation of I2C signals from one voltage reference to another, both the high-level and low-level voltage thresholds need to be translated. However, these threshold voltages are not mentioned in the datasheet of…

View FAQ threads