TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to read and write Ethernet PHY registers using a Linux terminal?

    David Creger
    David Creger
    There are several different tools available in a Linux environment to read and write registers on a TI PHY. Several of these options are listed below. MII read: This is the only command which can and must be used in U-boot. Stop the autoboot process…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: How to disable 25MHz clock on clkout pin?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TC812S-Q1 For DP83TC812S/R and DP83TC814-Q1 if clkout pin is not being used to provide a clock signal to another component, then it is recommended to shut down this clock output and reduce its impact on EM emissions. Clkout's output…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Which conformal coating is recommended for Ethernet PHY products?

    Vikram Sharma
    Vikram Sharma
    TI does not have a recommendation for any specific conformal coat or underfill product. In some temperature ranges these materials can be detrimental if the conformal coating or underfill product has a mismatched CTE vs. solder joint (Z axis). This…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: How to test the link-quality using DP83867's BIST and status registers?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867IR DP83867 PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These parameters…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: How to check throughput without depending upon MAC?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TD510E DP83TD510E PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How do I choose magnetics for my industrial PHY?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E There are 5 key parameters to look out for when selecting magnetics: Magnetic type (specifically for integrated RJ-45/Magnetic component) Can the recommended MDI configuration still be met with this component? Turns…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TLK2711-SP: Eye Mask Recommendations

    Drew Miller1
    Drew Miller1
    Part Number: TLK2711-SP There have been some questions regarding the TLK2711-SP eye mask related to the following E2E thread, so I am hoping to clarify them in this post. TLK2711-SP: Is there an EYE diagram mask definition available? - Space & High…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH941AS-Q1: How to configure FPD-Link III 94x audio

    Ryan Fleetham
    Ryan Fleetham
    Part Number: DS90UH941AS-Q1 How do I configure audio for FPD-Link III 94x devices?
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: In enhanced mode, how does DP83826 strapping work?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E When configuring DP83826 in Enhanced Mode, please consult the following flowchart to understand how the different strap pins configure the PHY into various modes.
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: How to read or write registers in extended register space of Ethernet PHY?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TG720S-Q1 write procedure for MMD "1F" registers: write reg<000D> = 0x001F write reg<000E> = <address> write reg<000D> = 0x401F write reg<000E> = <value> read procedure for MMD "1F" registers: write reg<000D> = 0x001F …
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    DS90UB954-Q1: Request for Artwork Review (With DS90UB953 PCB) 0 Locked

    152 views
    2 replies
    Latest over 3 years ago
    by Nicholas Darash
  • Suggested Answer

    SN75DP139: schematic check 0 Locked

    209 views
    1 reply
    Latest over 3 years ago
    by David (ASIC) Liu
  • Answered

    SN65LBC179A: SN65LBC179A vs SN65LBC179 0 Locked

    354 views
    3 replies
    Latest over 3 years ago
    by Eric Hackett
  • Suggested Answer

    DP83TD510E: Low power controller with MAC for use in Ethernet-APL low power (intrinsically safe) application 0 Locked

    441 views
    2 replies
    Latest over 3 years ago
    by Vikram Sharma
  • Answered

    TUSB8020B: Design Questions 0 Locked

    358 views
    4 replies
    Latest over 3 years ago
    by JMMN
  • Not Answered

    TLIN1027-Q1: TLIN1027 can't communicate with K-line normally, and there is a slight fever 0 Locked

    375 views
    1 reply
    Latest over 3 years ago
    by Danny Bacic
  • Suggested Answer

    SN65LBC031: ESD of SN65LBC031DRG4 0 Locked

    139 views
    1 reply
    Latest over 3 years ago
    by Tyler Townsend
  • Suggested Answer

    DS90UB954-Q1: About DS90UB954-Q1 GPIOcontrol 0 Locked

    169 views
    2 replies
    Latest over 3 years ago
    by Shruti More
  • Answered

    DP83825I: Master-Slave clock options for back-back repeater mode 0 Locked

    451 views
    2 replies
    Latest over 3 years ago
    by Gerome Cacho
  • Suggested Answer

    Serialize from mi 18-24RGB protocol 0 Locked

    122 views
    1 reply
    Latest over 3 years ago
    by David (ASIC) Liu
  • Not Answered

    DP83867IR: Issue with dp83867IR connecting after auto negotiation has completed 0 Locked

    737 views
    6 replies
    Latest over 3 years ago
    by Gerome Cacho
  • Answered

    HD3SS3411: Time to switch between "Normal" & "Shutdown" modes 0 Locked

    196 views
    1 reply
    Latest over 3 years ago
    by Brian Zhou
  • Not Answered

    TPS65987D: Configuration 0 Locked

    369 views
    8 replies
    Latest over 3 years ago
    by Chuck Branch
  • Suggested Answer

    DSLVDS1047: The current of DSLVDS1047-1048EVM 0 Locked

    310 views
    3 replies
    Latest over 3 years ago
    by Malik Barton57
  • Suggested Answer

    TUSB2046I: What kind of clock source is allowed for 48 MHz input? Datasheet says no crystal, should I use a MEMS oscillator? 0 Locked

    262 views
    1 reply
    Latest over 3 years ago
    by Malik Barton57
  • Suggested Answer

    THVD1500: ESD Protection Requirement 0 Locked

    259 views
    3 replies
    Latest over 3 years ago
    by Eric Hackett
  • Suggested Answer

    DS90UB927Q-Q1: Can 927 I2C be pull up by 1.8V? 0 Locked

    176 views
    2 replies
    Latest over 3 years ago
    by Jiawei Hu1
  • Answered

    XIO2001: PCI Bus Electrical Characteristics CIN 0 Locked

    209 views
    1 reply
    Latest over 3 years ago
    by Clemens Ladisch
  • Not Answered

    DS90UB947-Q1: LVDS clock and data layout 0 Locked

    230 views
    7 replies
    Latest over 3 years ago
    by Aaron Heng
  • Suggested Answer

    DP83867IS: 8.5.3 LED Operation From 1.8-V I/O VDD Supply 0 Locked

    148 views
    1 reply
    Latest over 3 years ago
    by Vikram Sharma
<>