TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DP83867E: Ethernet PHY SGMII Vdiff Upper and Lower Input Limits

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869 The DP83867 and DP83869 both have the same Vdiff Upper and Lower Input Limits of: 100 mV and 800 mV
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] What capacitance should my ESD diode be?

    Ethan Sempsrott
    Ethan Sempsrott
    Other Parts Discussed in Thread: ESD2CANXL24-Q1 , ESD2CAN24-Q1 , ESD2CANFD24-Q1 , ESD122 What should be considered when selecting a diode with parasitic capacitance?
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83825I: How to adjust the Output Differential Voltage (VOD) of the DP83825I

    David Creger
    David Creger
    4540.DP83825I VOD Adjustment.pptx
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720R-Q1: Why is my SGMII eye measurement distorted?

    Melissa Chang
    Melissa Chang
    Part Number: DP83TG720R-Q1 SGMII signal is high frequency low-voltage differential signal. Both layout design and measurements need to be accurate for good eye diagram capture. Common board design guidelines: 100ohms+/-10% differential traces…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Can an ESD diode experience latch-up?

    Ethan Sempsrott
    Ethan Sempsrott
    Other Parts Discussed in Thread: STRIKE Is there a risk of latch-up with ESD diodes? Should this be taken into design consideration?
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] What is the difference between TLP and 8/20μs clamping voltages on ESD diode datasheets?

    Ethan Sempsrott
    Ethan Sempsrott
    Other Parts Discussed in Thread: ESD321 , STRIKE What is the TLP clamping voltage, and how is it different compared to the 8/20μs clamping voltage? Take the electrical characteristics for ESD321 as an example:
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] LMH0303: How to Tune LMH0303 LMH0307 Cable Fault detection

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH0303 Other Parts Discussed in Thread: LMH0307 , Background: The LMH0307/3 termination fault detection was never designed to be precise; its purpose is to provide an indication when no cable is connected to the output (near end). The…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UB953-Q1: Does this Serializer have failure mode regarding delayed/frozen video transmission?

    Weicheng Li
    Weicheng Li
    Part Number: DS90UB953-Q1 Hi TI expert Can you pls help to confirm if the serializer (DS90UB953)can have Frozen and delayed video output failure modes? If Yes, pls share the safety mechanisms for these failure modes. Thanks Br Weicheng
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] AM6x to DP83867IR: How to read/write register values in DP83867 with addresses above 0x001F?

    Rimika Gupta
    Rimika Gupta
    Part Number: DP83867IR Problem Statement: Hi Expert, How to read/write register values in DP83867 with addresses above 0x001F? Regards
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: How does Strap1 (CLKOUT/LED1) work on DP83826?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E DP83826's Strap1 (CLKOUT/LED1) is an internal PU (Pull-up) strap pin. Strapping this high (either by default or external PU) will enable Odd Nibble Detection in the PHY. Strapping this low will disable Odd Nibble Detection as well…
    • over 2 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TPS65981: tps65981 0 Locked

    516 views
    5 replies
    Latest over 5 years ago
    by pdjuandi
  • Answered

    TUSB1044: I2C control in GPIO Mode 0 Locked

    375 views
    1 reply
    Latest over 5 years ago
    by David (ASIC) Liu
  • Answered

    TCAN4550: TCAN4550 Vccout pin gives 5.5V output 0 Locked

    435 views
    8 replies
    Latest over 5 years ago
    by Jonathan Nerger
  • Suggested Answer

    DS90UB948-Q1: MAP TOOLS testing result 0 Locked

    535 views
    11 replies
    Latest over 5 years ago
    by Vishy Viswanathan
  • Suggested Answer

    TUSB3410: Linux driver (RHEL 8.2) 0 Locked

    453 views
    2 replies
    Latest over 5 years ago
    by Malik Barton57
  • Answered

    TUSB3410: Is there Linux (REHL 8.2) driver for TUSB3410? 0 Locked

    289 views
    2 replies
    Latest over 5 years ago
    by Malik Barton57
  • Not Answered

    DP83TD510E-EVM: Cannot get link to establish with DP83822 portion of DP83TD510E-EVM 0 Locked

    1731 views
    6 replies
    Latest over 5 years ago
    by Justin Lazaruk
  • Answered

    DS90UB933-Q1: Why we recommend Dout+ and Dout- different capacitor value? 0 Locked

    261 views
    1 reply
    Latest over 5 years ago
    by Casey McCrea
  • Answered

    DP141RLJEVM: how to use DRV_PK? 0 Locked

    484 views
    5 replies
    Latest over 5 years ago
    by David (ASIC) Liu
  • Answered

    TMDS181: Does TMDS181 support SSC(Spread spectrum clocking) feature? 0 Locked

    645 views
    2 replies
    Latest over 5 years ago
    by David (ASIC) Liu
  • Suggested Answer

    SN65HVD21M-EP: Pin Failure 0 Locked

    318 views
    3 replies
    Latest over 5 years ago
    by Hao L
  • Answered

    SN65DSI86: Help on SN65DSI86 set up for DSI Tuner and one more questions on SN65DSI86 0 Locked

    745 views
    6 replies
    Latest over 5 years ago
    by David (ASIC) Liu
  • Suggested Answer

    Request for introduction to interface IC 0 Locked

    260 views
    3 replies
    Latest over 5 years ago
    by Parker Dodson
  • Not Answered

    TUSB2036: TUSB2036 not detecting 0 Locked

    671 views
    9 replies
    Latest over 5 years ago
    by JMMN
  • Answered

    SN65DSI85: Is there a simulation model for SN65DSI85? 0 Locked

    243 views
    1 reply
    Latest over 5 years ago
    by Ikechukwu Anyiam
  • Not Answered

    MAX3221E: RS232 cable connected ,the TX wave is mistake , But Loopback is correct 0 Locked

    303 views
    2 replies
    Latest over 5 years ago
    by Hao L
  • Not Answered

    TUSB8041: for some type of U disk transfer drop 0 Locked

    242 views
    1 reply
    Latest over 5 years ago
    by Malik Barton57
  • Suggested Answer

    SN65HVD75: SN65HVD75: Output issue 0 Locked

    805 views
    8 replies
    Latest over 5 years ago
    by Hao L
  • Answered

    TUSB212: Should TUSB212 be placed at host or device side 0 Locked

    382 views
    5 replies
    Latest over 5 years ago
    by Malik Barton57
  • Suggested Answer

    TUSB212: Trace Length Specification 0 Locked

    386 views
    5 replies
    Latest over 5 years ago
    by Malik Barton57
<>