TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS125DF111: How to capture a full eye opening measurement using SMBus registers

    Lucas Wolter
    Lucas Wolter
    Part Number: DS125DF111 Other Parts Discussed in Thread: DS110DF111 , , DS100DF410 , DS110DF410 , DS125DF410 Tool/software: In this FAQ, I will cover the SMBus register sequence to capture a full eye opening measurement. This FAQ applies to the following…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: Using EyeScan to Optimize CTLE Setting on Your PCIe Redriver

    Nick Peabody
    Nick Peabody
    Part Number: DS320PR810 Tool/software: Hi All, Texas Instruments uses PCIe redrivers to perform signal conditioning on medium to upper medium loss systems. The redriver is effective in a wide variety of systems with losses ranging from -36dB to -56dB…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP++ & Dual Mode Implementation using a DP redriver

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP2004 Tool/software: What is Dual Mode Dual mode or DP++ allows for a DP source to output a HDMI signal to a sink without using an active protocol converter. The DP source must be DP++ capable for dual mode operation. The key considerations…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: How should PCIe redriver PD pins be configured?

    Evan Su
    Evan Su
    Part Number: DS320PR810 Tool/software: TI PCIe Gen 5/Gen 4 redrivers have powerdown (PD or PWDN) pins. How should I configure them, and why does TI suggest connecting them to inverted PERST# or PRSNT#?
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] SN65DPHY440SS: What is the design constraint for DPHY440 lane 0 when using in a MIPI CSI design?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: SN65DPHY440SS Other Parts Discussed in Thread: SN75DPHY440SS Tool/software: I'm utilizing the SN75DPHY440SS in 4 lane configuration with default configuration parameters, sourced by a CSI-2 source. Lanes 1, 2, and 3 are correctly driven and…
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1142: How to properly connect the TUSB1142 FLIP pin to the TPS2583xA-Q1 CC controller

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: TUSB1142 Other Parts Discussed in Thread: TPS25820 , Tool/software: The TUSB1142 design uses the Flip signal from a TPS25820 to switch the SuperSpeed signals from a USB Type C connector. We are not able to get SuperSpeed to work at all.
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DS280DF810: Why is 25G/28G Retimer PRBS Generator Not Working?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Other Parts Discussed in Thread: DS250DF410 Tool/software: Introduction: One common debug question when using TI's 25G/28G is why is the PRBS generator not working? This FAQ will review the key criteria for the retimer PRBS generator…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TUSB211A: Why does the USB 2.0 redriver not appear to work when taking eye-diagrams?

    Undrea Fields
    Undrea Fields
    Part Number: TUSB211A Tool/software: In order to perform eye-diagram testing, the TUSB211A and other USB 2.0 redrivers must first detect the scope termination after power on or reset. Once termination has been detected, then the redriver will enable the…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DS280DF810: Which 25/28G Retimer Should I Select?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Other Parts Discussed in Thread: DS250DF210 , DS250DF230 , DS250DF410 , DS250DF810 , Tool/software: TI has several retimers in its 25/28G retimer product family. This FAQ breaks down some of the key differences between TI's 25…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DS280DF810: How can I calculate estimated signal conditioner power consumption?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Tool/software: When implementing a signal conditioning device in a system, one design consideration is the device power consumption. In order to address this design consideration, it's valuable to understand how to calculate the…
    • over 2 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TCA9539-Q1: about power dissipation 0 Locked

    313 views
    1 reply
    Latest over 2 years ago
    by Jack Guan
  • Answered

    DS90UB9722-Q1: ADC ExtVol0/1 0 Locked

    501 views
    4 replies
    Latest over 2 years ago
    by Glenn Uranga
  • Suggested Answer

    TUSB2E22: Requirement for a eUSB2 host and device 0 Locked

    398 views
    1 reply
    Latest over 2 years ago
    by Undrea Fields
  • Suggested Answer

    TCAN1145-Q1: How to wake the MCU by TCAN1145 with PN function? 0 Locked

    453 views
    3 replies
    Latest over 2 years ago
    by Eric Hackett
  • Not Answered

    DS90UB971-Q1: Serializer CRC related 0 Locked

    320 views
    1 reply
    Latest over 2 years ago
    by Hamzeh Jaradat
  • Answered

    SN65DP159: SN65DP159RSBR SN65DP159RSBR I2C SRC Routing (Pins 38/39) 0 Locked

    591 views
    3 replies
    Latest over 2 years ago
    by Vishesh Pithadiya
  • Suggested Answer

    PCA9306: PCA9306 vs TXS0102 0 Locked

    710 views
    2 replies
    Latest over 2 years ago
    by Clemens Ladisch
  • Answered

    TS3USB221: for eARC mux application 0 Locked

    427 views
    1 reply
    Latest over 2 years ago
    by Ryan Kitto
  • Suggested Answer

    LMH0050: Implementation of provided driver RTL only works at SD speed 0 Locked

    738 views
    10 replies
    Latest over 2 years ago
    by Zach Stokes
  • Not Answered

    DP83867CS: Differences between DP83867CSRGZ and DP83867ERGZ 0 Locked

    1215 views
    20 replies
    Latest over 2 years ago
    by Alvaro (Al-vuh-roe) Reyes
  • Not Answered

    DP83867E: Minimum Package Height? 0 Locked

    311 views
    3 replies
    Latest over 2 years ago
    by Hillman Lin
  • Suggested Answer

    DS90UB936-Q1: Can single crytal drive 2 DES 936?? 0 Locked

    634 views
    1 reply
    Latest over 2 years ago
    by Logan Cummins
  • Answered

    DP83867E: About MDIO operation with external microcontroller 0 Locked

    532 views
    2 replies
    Latest over 2 years ago
    by Hillman Lin
  • Answered

    SN65DP159: DP Retimer/Redriver 0 Locked

    838 views
    5 replies
    Latest over 2 years ago
    by Vishesh Pithadiya
  • Suggested Answer

    SN65DSI84-Q1: How to intentionally generate an IRQ 0 Locked

    446 views
    3 replies
    Latest over 2 years ago
    by Vishesh Pithadiya
  • Suggested Answer

    TCAN1042-Q1: TCAN1042 ISO16845 test report 0 Locked

    589 views
    4 replies
    Latest over 2 years ago
    by Eric Schott1
  • Not Answered

    TUSB8044A: using the TUSB8044A HUB, the problem of plugging and unplugging peripherals may not be recognized. 0 Locked

    1498 views
    23 replies
    Latest over 2 years ago
    by Brian Zhou
  • Not Answered

    TIC12400EVM-KIT: Interface with Mcu 0 Locked

    642 views
    1 reply
    Latest over 2 years ago
    by Jonathan Nerger
  • Suggested Answer

    SN65HVD30: sn65hvd30d thermal information 0 Locked

    316 views
    1 reply
    Latest over 2 years ago
    by Amy
  • Answered

    HD3SS215: DP OVER TYPE C TO DUAL HDMI CONVERTER 0 Locked

    439 views
    1 reply
    Latest over 2 years ago
    by David (ASIC) Liu
<>