TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] Linear vs. Limited Mode in Redrivers

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 Linear Mode: In linear mode the data received from the GPU’s transmitter is the data that will be sent out of the TX end of the redriver. This means that the GPU’s voltage swing, pre-emphasis…
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TUSB216I: How do you create a system with a 10 meter passive cable using a USB2 redriver?

    Ryan Kitto
    Ryan Kitto
    Part Number: TUSB216I Other Parts Discussed in Thread: TUSB217A , TUSB216-Q1 , , TUSB216 , TUSB211A I want to create a system that can support USB2 while utilizing a 10 meter passive cable. Which redriver(s) should I use, and how should they be configured…
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] USB-C CC and PD controller differences

    Shane Hauser
    Shane Hauser
    Do I need to use a CC controller or PD controller for my USB-C application?
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] How to control VBUS on a USB-C port

    Shane Hauser
    Shane Hauser
    Other Parts Discussed in Thread: TUSB320 How do I control the VBUS on my USB-C downstream facing or dual-role port?
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TDP1204: When to AC or DC couple the HDMI 2.1 output?

    Zach Dryer
    Zach Dryer
    Part Number: TDP1204 Up until HDMI 2.1, source output AC coupling was not clearly defined. However, now with HDMI 2.1 AC coupling is clearly defined. However, how can the designer determine when to AC or DC couple the HDMI 2.1 output?
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Potential TI Solutions for Video Protocol Conversion

    Zach Dryer
    Zach Dryer
    What potential solutions does TI offer for video protocol conversion?
    • Answered
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: Where can I find the latest Linux Drivers for DP83TG720 and DP83TG812/3/4?

    Melissa Chang
    Melissa Chang
    Part Number: DP83TG720S-Q1 Attached are the latest drivers tested on Kernel 5.10: GitHub - TexasInstruments/ti-ethernet-software: Repository for Ethernet PHY drivers for Linux and RTOS. The DP83TC812 driver can be used for the DP83TC813 and DP83TC814…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DS160PR410: Difference Between IBIS-AMI versus IBIS Modeling

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: DS160PR410 Other Parts Discussed in Thread: DS160PR810 , LMH0340 IBIS stands for Input/Output Buffering Information Specifications while AMI stands for Algorithm modeling Interface. In short, IBIS is used to describe analog behavior of…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: My PHY won't link up

    David Creger
    David Creger
    Part Number: DP83TC812S-Q1 Link status is shown in register 0x1 bit[2]. Link failing to show as up can be caused by many issues. Please see the following debug guide which walks through several of the possible causes and fixes. Specifically see section…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC813S-Q1: How to output LED1 signal on pin 14

    David Creger
    David Creger
    Part Number: DP83TC813S-Q1 By default, pin 14 of the DP83TC813 will output the CLKOUT signal. To instead have the LED1 signal on pin 14, write to the below registers. 0x045F = 0x000F 0x0452 = 0x0000 0x0451 = 0x0009
    • over 2 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    P82B96: VIL 0 Locked

    347 views
    1 reply
    Latest over 2 years ago
    by Jack Guan
  • Suggested Answer

    TCA9539-Q1: about power dissipation 0 Locked

    313 views
    1 reply
    Latest over 2 years ago
    by Jack Guan
  • Answered

    DS90UB9722-Q1: ADC ExtVol0/1 0 Locked

    501 views
    4 replies
    Latest over 2 years ago
    by Glenn Uranga
  • Suggested Answer

    TUSB2E22: Requirement for a eUSB2 host and device 0 Locked

    398 views
    1 reply
    Latest over 2 years ago
    by Undrea Fields
  • Suggested Answer

    TCAN1145-Q1: How to wake the MCU by TCAN1145 with PN function? 0 Locked

    453 views
    3 replies
    Latest over 2 years ago
    by Eric Hackett
  • Not Answered

    DS90UB971-Q1: Serializer CRC related 0 Locked

    320 views
    1 reply
    Latest over 2 years ago
    by Hamzeh Jaradat
  • Answered

    SN65DP159: SN65DP159RSBR SN65DP159RSBR I2C SRC Routing (Pins 38/39) 0 Locked

    591 views
    3 replies
    Latest over 2 years ago
    by Vishesh Pithadiya
  • Suggested Answer

    PCA9306: PCA9306 vs TXS0102 0 Locked

    710 views
    2 replies
    Latest over 2 years ago
    by Clemens Ladisch
  • Answered

    TS3USB221: for eARC mux application 0 Locked

    427 views
    1 reply
    Latest over 2 years ago
    by Ryan Kitto
  • Suggested Answer

    LMH0050: Implementation of provided driver RTL only works at SD speed 0 Locked

    738 views
    10 replies
    Latest over 2 years ago
    by Zach Stokes
  • Not Answered

    DP83867CS: Differences between DP83867CSRGZ and DP83867ERGZ 0 Locked

    1215 views
    20 replies
    Latest over 2 years ago
    by Alvaro (Al-vuh-roe) Reyes
  • Not Answered

    DP83867E: Minimum Package Height? 0 Locked

    311 views
    3 replies
    Latest over 2 years ago
    by Hillman Lin
  • Suggested Answer

    DS90UB936-Q1: Can single crytal drive 2 DES 936?? 0 Locked

    634 views
    1 reply
    Latest over 2 years ago
    by Logan Cummins
  • Answered

    DP83867E: About MDIO operation with external microcontroller 0 Locked

    532 views
    2 replies
    Latest over 2 years ago
    by Hillman Lin
  • Answered

    SN65DP159: DP Retimer/Redriver 0 Locked

    838 views
    5 replies
    Latest over 2 years ago
    by Vishesh Pithadiya
  • Suggested Answer

    SN65DSI84-Q1: How to intentionally generate an IRQ 0 Locked

    446 views
    3 replies
    Latest over 2 years ago
    by Vishesh Pithadiya
  • Suggested Answer

    TCAN1042-Q1: TCAN1042 ISO16845 test report 0 Locked

    589 views
    4 replies
    Latest over 2 years ago
    by Eric Schott1
  • Not Answered

    TUSB8044A: using the TUSB8044A HUB, the problem of plugging and unplugging peripherals may not be recognized. 0 Locked

    1498 views
    23 replies
    Latest over 2 years ago
    by Brian Zhou
  • Not Answered

    TIC12400EVM-KIT: Interface with Mcu 0 Locked

    642 views
    1 reply
    Latest over 2 years ago
    by Jonathan Nerger
  • Suggested Answer

    SN65HVD30: sn65hvd30d thermal information 0 Locked

    316 views
    1 reply
    Latest over 2 years ago
    by Amy
<>