Part Number: TMS570LC4357

Tool/software:

1. What is the remote frame used for?

2. What is the difference between remote frame and data frame?

3. Is a transmit object used for remote frame?

4. Should the DLC of remote frame be identical to the DLC of the corresponding (requested) data frame?

5. How to configure the remote frame?

6. How to configure the requested data frame to response the remote frame automatically?

Part Number: TMS570LS1224

Tool/software:

The TMS57LS12x and TMS570LS07x have one LIN/SCI. If an extra SCI is required, we can implement an SCI using N2HET module. TI provides example code of N2HET emulated SCI. 

I got several feedbacks that the N2HET emulated SCI might get a corrupted byte after receiving 6~7 bytes. How to resolve this issue?

Part Number: TMS570LC4357

Tool/software:

1. Why does the TCF generation fail?

2. What are the possible reasons for build failure?

3. When the test execution hung, what should we do?

5. Can I use HalCoGen TAU to test source file other than HalCoGen generated files? 

Part Number: LP-AM243

Tool/software:

I am trying to modify the gpio_input_interrupt example for the R5F0-0 core to direct the GPIO interrupt to the PRU core.

Requirement: GPIO1_0 interrupt ->  MAIN_GPIOMUX_INTROUTER0_OUTP_18 -> IEP0_CAP

SysConfig does not seem to allow the configuration of PRU specific MAIN_GPIOMUX_INTROUTER_OUTP, as the only visible options for interrupt router output are MAIN_GPIOMUX_INTROUTERS[0:7].

As a workaround, I copied files generated from the syscfg file and tried to modify the rmIrqReq.dst_host_irq parameter in the Sciclient_gpioIrqSet function manuallybut this also doesn't work and results in a Sciclient error.

How can I solve this problem ?

Part Number: MCU-PLUS-SDK-AM243X

Tool/software:

Hi, can AM243x OSPI work with a PSRAM? If so, which are the HW and SW modifications required? When is OSPI PSRAM a good fit as memory expansion?

Part Number: TMS570LC4357

Tool/software:

After triggering an ESM fault, performing a warm reset without clearing the ERR pin status by writing esmREG->EKR = 5

after rebooting, writing twriting esmREG->EKR = 5 has no effect, the counter does not decrement, and the ERR pin remains low.

At this point, if another ESM fault is triggered, the counter increments, and the ERR pin goes high

Part Number: AM2432

Tool/software:

Hi Expert,

customer want to use AM24 GPIO to drive a LED, so they want to know what the max current is we can output from GPIO? Thanks for support in advance.

BR,

Biao

Part Number: AM2434

Tool/software:

Hi,
is it possible to get the pin list for the AM2434 in excel format?

Part Number: AM2434

Tool/software:

Hello TI,

is it possible to configure 1.8V and 3.3V domains in SysConfig and select I/O pins according to the preferred voltage?

I have seen a drop-down box for some of the pins offering me a selection, but it is always greyed out. 

I was unable to find a setting to configure which power rails run of 3V3 and 1V8-

How can I do this properly?

Thank you and regards,

Claus

Part Number: MCU-PLUS-SDK-AM263PX

Tool/software:

Hi Experts,

I am facing following problems while installing the MacOS installer of MCU-PLUS-SDK. It says the .dmg file is damaged and it cannot be installed. Could you please check this.

Regards

Thank you.