Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] TUSB522P: Co-layout with TUSB1002A

    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A Can TUSB522P and TUSB1002A co-layout?

  • [FAQ] DP83822: How to improve margin in 10BaseTe TP_IDL Compliance Tests?

    Part Number: DP83822 The DP83822 has extended registers than can help improve the margins for 10BaseTe TP_IDL tests. Register 0x0023[11:8] = 0x8 by Default Setting 0x0023[11:8] to 0x9 or 0xA can improve Margins. See Pictures below (TP_IDL Load2…

  • [FAQ] DP83TD510E: What is the potential swing levels of DP83TD510E when linking up with link partner?

    Part Number: DP83TD510E

  • [FAQ] Ethernet PHY - Functional Safety FIT Rate, FMD and Pin FMA Reports

    We currently do not have Functional Safety FIT Rate, FMD, and Pin FMA Report available for devices released before DP83TC812.

  • [FAQ] What different types of Reset are available on a TI Ethernet PHY?

    There are four different types of resets available on a TI Ethernet PHY, each with it's own use case. Pin Reset: Activated by asserting the Reset pin low. Digital core is reset, link up process will restart. All internal registers will reinitialize…

  • [FAQ] What is a WUP and how does a CAN transceiver send and receive a WUP on the BUS?

    Other Parts Discussed in Thread: TCAN1043A-Q1 Introduction Any CAN transceiver that has an Inhibit (INH) pin will also have a sleep mode. The purpose of the INH pin is to be able to automatically turn off the voltage regulator for your MCU/Board. This…

  • [FAQ] DS90UB935-Q1: FPD-Link Data Rate 3Gbps?

    Part Number: DS90UB935-Q1 Does the DS90UB935-Q1 FPD-Link interface run at 3Gbps or 4Gbps?

  • [FAQ] DS90UB954-Q1: CSI-2 Lanes SER vs. DES

    Part Number: DS90UB954-Q1 Does the number of CSI-2 lanes programmed for 954 need to match the number of input lanes for 953/935?

  • [FAQ] DS90UB953-Q1: Imager Data Rate Support

    Part Number: DS90UB953-Q1 ​​​Can the DS90UB953-Q1 support my imager?

  • [FAQ] DP83867E: How to force 10/100/1000 Mbps speed in Ethernet PHYs?

    Part Number: DP83867E Other Parts Discussed in Thread: USB-2-MDIO To force a specific speed, auto-negotiation is left enabled while disabling advertisements for all non-desired speeds. The scripts to do this in the USB-2-MDIO interface for the DP83867…

View FAQ threads