TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to read and write Ethernet PHY registers using a Linux terminal?

    David Creger
    David Creger
    There are several different tools available in a Linux environment to read and write registers on a TI PHY. Several of these options are listed below. MII read: This is the only command which can and must be used in U-boot. Stop the autoboot process…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: How to disable 25MHz clock on clkout pin?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TC812S-Q1 For DP83TC812S/R and DP83TC814-Q1 if clkout pin is not being used to provide a clock signal to another component, then it is recommended to shut down this clock output and reduce its impact on EM emissions. Clkout's output…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Which conformal coating is recommended for Ethernet PHY products?

    Vikram Sharma
    Vikram Sharma
    TI does not have a recommendation for any specific conformal coat or underfill product. In some temperature ranges these materials can be detrimental if the conformal coating or underfill product has a mismatched CTE vs. solder joint (Z axis). This…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: How to test the link-quality using DP83867's BIST and status registers?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867IR DP83867 PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These parameters…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: How to check throughput without depending upon MAC?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TD510E DP83TD510E PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How do I choose magnetics for my industrial PHY?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E There are 5 key parameters to look out for when selecting magnetics: Magnetic type (specifically for integrated RJ-45/Magnetic component) Can the recommended MDI configuration still be met with this component? Turns…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TLK2711-SP: Eye Mask Recommendations

    Drew Miller1
    Drew Miller1
    Part Number: TLK2711-SP There have been some questions regarding the TLK2711-SP eye mask related to the following E2E thread, so I am hoping to clarify them in this post. TLK2711-SP: Is there an EYE diagram mask definition available? - Space & High…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH941AS-Q1: How to configure FPD-Link III 94x audio

    Ryan Fleetham
    Ryan Fleetham
    Part Number: DS90UH941AS-Q1 How do I configure audio for FPD-Link III 94x devices?
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: In enhanced mode, how does DP83826 strapping work?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E When configuring DP83826 in Enhanced Mode, please consult the following flowchart to understand how the different strap pins configure the PHY into various modes.
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: How to read or write registers in extended register space of Ethernet PHY?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TG720S-Q1 write procedure for MMD "1F" registers: write reg<000D> = 0x001F write reg<000E> = <address> write reg<000D> = 0x401F write reg<000E> = <value> read procedure for MMD "1F" registers: write reg<000D> = 0x001F …
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    [TVS Diode] Request a replacement product recommendation 0 Locked

    230 views
    1 reply
    Latest over 4 years ago
    by Matt Smith
  • Answered

    TCAN1162-Q1: SIC function implemented? 0 Locked

    498 views
    2 replies
    Latest over 4 years ago
    by Josef Warta
  • Answered

    TCAN4550: Worst case test condition 0 Locked

    199 views
    3 replies
    Latest over 4 years ago
    by Eric Schott1
  • Suggested Answer

    TCAN1043-Q1: Could TCAN1043-Q1 support 5M? 0 Locked

    210 views
    1 reply
    Latest over 4 years ago
    by Eric Schott1
  • Not Answered

    TCAN1042V-Q1: TX/RX Waveform not followed well 0 Locked

    509 views
    1 reply
    Latest over 4 years ago
    by Eric Schott1
  • Suggested Answer

    Does TI have a similar like to LAN8710A ? 0 Locked

    447 views
    3 replies
    Latest over 4 years ago
    by Vikram Sharma
  • Answered

    DS90UB964-Q1EVM: TDA3-EVM 0 Locked

    1192 views
    24 replies
    Latest over 4 years ago
    by Sujith
  • Suggested Answer

    DS90UB954-Q1: Piece Wise Linear Compressed 12 bit Format 0 Locked

    151 views
    3 replies
    Latest over 4 years ago
    by Hamzeh Jaradat
  • Answered

    TLK2711-SP: how to exit the power down mode correctly? 0 Locked

    284 views
    3 replies
    Latest over 4 years ago
    by Gianni Tornaghi
  • Suggested Answer

    XIO2001: Customization Required for Device Use 0 Locked

    162 views
    3 replies
    Latest over 4 years ago
    by Clemens Ladisch
  • Not Answered

    TCA6418E: TI solution suggestion 0 Locked

    161 views
    1 reply
    Latest over 4 years ago
    by Clemens Ladisch
  • Answered

    DS90UB941AS-Q1: how to configure to drive 2 independent touch screen 0 Locked

    416 views
    2 replies
    Latest over 4 years ago
    by fang yina
  • Answered

    DS90UB941AS-Q1: configure ds90ub941 as single DSI input and two FPD-LINK outputs 0 Locked

    937 views
    13 replies
    Latest over 4 years ago
    by Weiguang Ding
  • Answered

    DS90UB928Q-Q1: Check the function of GPIO pins 0 Locked

    247 views
    1 reply
    Latest over 4 years ago
    by Michael.Walker
  • Not Answered

    TPS25750: two TPS25750s use in no battery circumstance 0 Locked

    311 views
    3 replies
    Latest over 4 years ago
    by Chuck Branch
  • Not Answered

    DS90UB954-Q1: REFCLK Sequencing? 0 Locked

    1083 views
    36 replies
    Latest over 4 years ago
    by Nicholas Darash
  • Not Answered

    DS90UB954-Q1EVM: Embedded metadata Height 0 Locked

    310 views
    3 replies
    Latest over 4 years ago
    by Nicholas Darash
  • Suggested Answer

    SN65LVDS86A: Reference design 0 Locked

    507 views
    1 reply
    Latest over 4 years ago
    by Ben Dattilo
  • Answered

    TPD6S300A: Proper ESD protection device for USB 3.1 Gen2, DisplayPort 1.4 0 Locked

    426 views
    4 replies
    Latest over 4 years ago
    by Ryotaro Fukui
  • Suggested Answer

    TPS25750: PD specification of TPS25750 0 Locked

    161 views
    3 replies
    Latest over 4 years ago
    by Chuck Branch
<>