Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] DS90UB935-Q1: FPD-Link Data Rate 3Gbps?

    Part Number: DS90UB935-Q1 Does the DS90UB935-Q1 FPD-Link interface run at 3Gbps or 4Gbps?

  • [FAQ] DS90UB954-Q1: CSI-2 Lanes SER vs. DES

    Part Number: DS90UB954-Q1 Does the number of CSI-2 lanes programmed for 954 need to match the number of input lanes for 953/935?

  • [FAQ] DS90UB953-Q1: Imager Data Rate Support

    Part Number: DS90UB953-Q1 ​​​Can the DS90UB953-Q1 support my imager?

  • [FAQ] DP83867E: How to force 10/100/1000 Mbps speed in Ethernet PHYs?

    Part Number: DP83867E Other Parts Discussed in Thread: USB-2-MDIO To force a specific speed, auto-negotiation is left enabled while disabling advertisements for all non-desired speeds. The scripts to do this in the USB-2-MDIO interface for the DP83867…

  • [FAQ] How to read and write Ethernet PHY registers using a Linux terminal?

    There are several different tools available in a Linux environment to read and write registers on a TI PHY. Several of these options are listed below. MII read: This is the only command which can and must be used in U-boot. Stop the autoboot process…

  • [FAQ] DP83TC812S-Q1: How to disable 25MHz clock on clkout pin?

    Part Number: DP83TC812S-Q1 For DP83TC812S/R and DP83TC814-Q1 if clkout pin is not being used to provide a clock signal to another component, then it is recommended to shut down this clock output and reduce its impact on EM emissions. Clkout's output…

  • [FAQ] Which conformal coating is recommended for Ethernet PHY products?

    TI does not have a recommendation for any specific conformal coat or underfill product. In some temperature ranges these materials can be detrimental if the conformal coating or underfill product has a mismatched CTE vs. solder joint (Z axis). This…

  • [FAQ] DP83867IR: How to test the link-quality using DP83867's BIST and status registers?

    Part Number: DP83867IR DP83867 PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These parameters…

  • [FAQ] DP83TD510E: How to check throughput without depending upon MAC?

    Part Number: DP83TD510E DP83TD510E PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These…

  • [FAQ] DP83867E: How do I choose magnetics for my industrial PHY?

    Part Number: DP83867E There are 5 key parameters to look out for when selecting magnetics: Magnetic type (specifically for integrated RJ-45/Magnetic component) Can the recommended MDI configuration still be met with this component? Turns…

View FAQ threads