Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] SN65DSI84: Swapping between DSI 83/84/85

    Part Number: SN65DSI84 Other Parts Discussed in Thread: SN65DSI83 , , SN65DSI85 Swapping DSI 83/84/85 FAQ Before we begin here is a brief overview of each part and its capabilities: SN65DSI83: SINGLE channel MIPI DSI to SINGLE channel LVDS Bridge…

  • [FAQ] TDP1204: What is the difference between the TDP1204 and the TMDS1204 HDMI 2.1 redrivers?

    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 When choosing to design in either TDP1204 and TMDS1204, the system designer should consider the differences between the two HDMI 2.1 redrivers. This thread highlights the differences and provides…

  • [FAQ] DP83869HM: SGMII Output Differential Voltage Clarification

    Part Number: DP83869HM The SGMII Output spec is slightly ambiguous, the purpose of this FAQ is to clear up the terminology. Our data sheet has the following spec: SGMII OUTPUT Min Typ Max Unit Output Differential Voltage …

  • [FAQ] How to Confirm Ethernet PHY Strapping

    Other Parts Discussed in Thread: DP83869 Our Ethernet PHYs have Hardware Bootstraps that allow the PHY to be configured without the need for register access and also set the PHY ID. Either one of these being mismatched can cause issues, e.g. PHY is configured…

  • [FAQ] DP83826I: How do I debug a PHY issue within an EtherCAT network?

    Part Number: DP83826I 3644.How to debug PHY level issues in EtherCAT networks.pdf

  • [FAQ] 10base-T and 10 base-Te difference

    What is the difference between 10Base-T and 10Base-Te?

  • [FAQ] DP83TD510E-EVM: How to use ping and iperf between two PCs through 510EVM Link?

    Part Number: DP83TD510E-EVM ping&iperf_510.ppt

  • [FAQ] DP83826E: How does pin 29 on DP83826 act depending on strap mode?

    Part Number: DP83826E DP83826 in Enhanced mode has a pin which is GPIO, pin 29. This pin can be an LED or can be used as CRS. When PHY is set in RMII mode, this pin can be reprogrammed to be LED or CRS. When MII is strapped, this pin is forced to be CRS…

  • [FAQ] DP83822I: How to use RMII repeater mode in DP83822?

    Part Number: DP83822I Could someone guide me on how to use DP83822 for RMII repeater mode?

  • [FAQ] DP83822I: Link up debug with DP83822

    Part Number: DP83822I

View FAQ threads