Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] SN65DSI86: SN65DSI86 Resolution Guide

    Part Number: SN65DSI86 What display resolution will the SN65DSI86 support?

  • [FAQ] DP83867E: What is the default mode of RGMII when using DP83867, shift or align?

    Part Number: DP83867E When bootstrapped to be in RGMII mode, DP83867 will be in shift mode by default; not align mode. The modes will be corroborated via Reg 0x32[1:0].

  • [FAQ] DP83869HM: How to generate 125MHz on CLKOUT pin for DP83869

    Part Number: DP83869HM DP83869HM needs an additional register to be written to enable CLKOUT modification. By default, this signal is a buffered version of the XI signal. Reg 0xC6 must have 0x10 written in order for the value in Reg 0x170[12:8] to take…

  • [FAQ] TI Ethernet PHY Capacitive Coupling (Transformerless Operation)

    Other Parts Discussed in Thread: DP83869 Summary: All of our Industrial Ethernet PHYs support Transformer-less Operation via Capacitive Coupling except for the DP83867. The DP83867 does not support Transformer-less Operation. List of Industrial…

  • [FAQ] DP83867E: Ethernet PHY SGMII Vdiff Upper and Lower Input Limits

    Part Number: DP83867E Other Parts Discussed in Thread: DP83869 The DP83867 and DP83869 both have the same Vdiff Upper and Lower Input Limits of: 100 mV and 800 mV

  • [FAQ] What capacitance should my ESD diode be?

    Other Parts Discussed in Thread: ESD2CANXL24-Q1 , ESD2CAN24-Q1 , ESD2CANFD24-Q1 , ESD122 What should be considered when selecting a diode with parasitic capacitance?

  • [FAQ] DP83825I: How to adjust the Output Differential Voltage (VOD) of the DP83825I

    4540.DP83825I VOD Adjustment.pptx

  • [FAQ] DP83TG720R-Q1: Why is my SGMII eye measurement distorted?

    Part Number: DP83TG720R-Q1 SGMII signal is high frequency low-voltage differential signal. Both layout design and measurements need to be accurate for good eye diagram capture. Common board design guidelines: 100ohms+/-10% differential traces…

  • [FAQ] Can an ESD diode experience latch-up?

    Other Parts Discussed in Thread: STRIKE Is there a risk of latch-up with ESD diodes? Should this be taken into design consideration?

  • [FAQ] What is the difference between TLP and 8/20μs clamping voltages on ESD diode datasheets?

    Other Parts Discussed in Thread: ESD321 , STRIKE What is the TLP clamping voltage, and how is it different compared to the 8/20μs clamping voltage? Take the electrical characteristics for ESD321 as an example:

View FAQ threads