TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197759 Discussions
  • Not Answered

    DM365 vpfe can not adjust the start pixel and start line 0 Locked

    746 views
    10 replies
    Latest over 13 years ago
    by doron sandroy
  • Answered

    Buffer was never with Ducati!! 0x1d3e5c0 A/libc(139): Fatal signal 11 (SIGSEGV) at 0x00000000 (code=1) 0 Locked

    768 views
    3 replies
    Latest over 13 years ago
    by Mayank Mangla
  • Not Answered

    How to add the linker order or compiler order to the CCS project 0 Locked

    228 views
    0 replies
    Started over 13 years ago
    by haibo xiang
  • Answered

    OMAP35xx internal temperature sensor 0 Locked

    248 views
    1 reply
    Latest over 13 years ago
    by BrandonAzbell
  • Answered

    android source for OMAP4460 0 Locked

    459 views
    2 replies
    Latest over 13 years ago
    by Israel Cepeda
  • Not Answered

    EMMC connect to the mmc0 0 Locked

    144 views
    0 replies
    Started over 13 years ago
    by Anson Yan1
  • Answered

    How to perform a polled SRIO read (NREAD and/or Maintenance Read) using CSL 0 Locked

    564 views
    2 replies
    Latest over 13 years ago
    by Marty
  • Not Answered

    C6678 EVM - not able to see USB/Ethernet connection 0 Locked

    311 views
    2 replies
    Latest over 13 years ago
    by 3478586
  • Not Answered

    Configure the AM335x core frequency when OPP50 0 Locked

    648 views
    3 replies
    Latest over 13 years ago
    by Sword Liu
  • Not Answered

    Android Froyo Porting on AM1808evm 0 Locked

    1365 views
    11 replies
    Latest over 13 years ago
    by charles brown1
  • Not Answered

    Use 10 bits raw data with A-Law compression 0 Locked

    165 views
    0 replies
    Started over 13 years ago
    by ChunChi Huang
  • Not Answered

    Is G.722 included in SDK for AM335X? 0 Locked

    187 views
    0 replies
    Started over 13 years ago
    by John J Wu
  • Not Answered

    UART signals 0 Locked

    248 views
    2 replies
    Latest over 13 years ago
    by alex dodo
  • Answered

    one wait singal using for multiple CS 0 Locked

    201 views
    3 replies
    Latest over 13 years ago
    by Pavel Botev
  • Answered

    FastRTS 1.42 math issue ! 0 Locked

    501 views
    3 replies
    Latest over 13 years ago
    by Daniel Wanninger
  • Answered

    Bringing GUI (IDE) of AM335x SDK 0 Locked

    770 views
    5 replies
    Latest over 13 years ago
    by Nitin Singh1
  • Answered

    Socket Sendto Error 0 Locked

    596 views
    2 replies
    Latest over 13 years ago
    by Brandy Jabkiewicz
  • Not Answered

    beaglebone 0 Locked

    100 views
    0 replies
    Started over 13 years ago
    by linux linuxer
  • Not Answered

    Run button in CCSv5 is not working - snapshot attached 0 Locked

    177 views
    0 replies
    Started over 13 years ago
    by Nitin Singh1
  • Not Answered

    bt.601 camera connection to dm8148 0 Locked

    1298 views
    10 replies
    Latest over 13 years ago
    by richard lee2
<>