TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DP83869HM: Bridge Mode Clarification

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83869HM The DP83869HM supports two types of Bridge Modes to translate data between two MAC interface types. The two types are: RGMII-to-SGMII mode SGMII-to-RGMII mode The naming convention implies MAC-to-PHY and the functionality…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] UART Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page UART Protection Highlights: Lower speed serial data transfer interface Operating lines: GND, ±TX, ±RX Datalines (±Tx, ±Rx) Operating voltage: 3.3V, recommended Vbr > 3.6V Data rates up to 5Mbps TI…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TCAN1043A-Q1: TCAN1043-Q1 0 Locked

    76 views
    1 reply
    Latest 4 months ago
    by Ethan Sempsrott
  • Suggested Answer

    DS560DF410: DS560DF410 Device Configuration and Programming 0 Locked

    65 views
    1 reply
    Latest 4 months ago
    by Drew Miller1
  • Suggested Answer

    DS560DF410: DS560DF410: IBIS Model 0 Locked

    60 views
    1 reply
    Latest 4 months ago
    by Drew Miller1
  • Suggested Answer

    DS125DF410: Temperature Dependency at Configuration 0 Locked

    248 views
    9 replies
    Latest 4 months ago
    by Drew Miller1
  • Not Answered

    SN65DPHY440SS: How to validate the re-timer, What are they test case doing the MIPI retimer 0 Locked

    105 views
    3 replies
    Latest 4 months ago
    by David (ASIC) Liu
  • Suggested Answer

    DP83867E: DP83867ERGZR: Transformer Connection 0 Locked

    84 views
    3 replies
    Latest 4 months ago
    by J
  • Suggested Answer

    TMUXHS4446: Need Mux details 0 Locked

    139 views
    3 replies
    Latest 4 months ago
    by Kameron Hill
  • Suggested Answer

    TPLD801: THIRD PART PROGRAMMER - TPLD 0 Locked

    79 views
    1 reply
    Latest 4 months ago
    by Ian Graham
  • Answered

    TUSB8044AEVM: TUSB8044AEVM: Request for Schematic and Layout Files (Altium Designer) 0 Locked

    218 views
    7 replies
    Latest 4 months ago
    by Brian Zhou
  • Answered

    P82B96: P82B96 does not follow I2C spec. 0 Locked

    300 views
    4 replies
    Latest 4 months ago
    by Warren Hawkins
  • Suggested Answer

    DP83TG720S-Q1: Feasibility of software configuration rate adjustment 0 Locked

    134 views
    3 replies
    Latest 4 months ago
    by Undrea Fields
  • Answered

    DP83822I: Transformer-less Configuration MLT-3 Register Setting 0 Locked

    116 views
    1 reply
    Latest 4 months ago
    by J
  • Answered

    TUSB321AI: Are PR_SWAP and DR_Swap CC Commands Support 0 Locked

    71 views
    1 reply
    Latest 4 months ago
    by Vishesh Pithadiya
  • Suggested Answer

    SN65DP159: DP AND DVI TO LVDS 0 Locked

    117 views
    1 reply
    Latest 4 months ago
    by David (ASIC) Liu
  • Suggested Answer

    LSF0204: I2C Rise time is too slow 0 Locked

    176 views
    4 replies
    Latest 4 months ago
    by Jack Guan
  • Answered

    SN75DPHY440SS: Inquiry for parts recommendation 0 Locked

    73 views
    1 reply
    Latest 4 months ago
    by David (ASIC) Liu
  • Answered

    LM8335EVM: Searching for PC software for LM8335EVM (GUI) 0 Locked

    268 views
    5 replies
    Latest 4 months ago
    by Martin Maurer
  • Answered

    DS560DF410: Can the DS560DF410 be used as a PRBS Pattern Generator and Error Detector? 0 Locked

    98 views
    1 reply
    Latest 4 months ago
    by Drew Miller1
  • Answered

    DP83822I: Auto-MDIX Inquiry 0 Locked

    84 views
    1 reply
    Latest 4 months ago
    by J
  • Answered

    DP83869EVM: DP83869EVM. Media Convertor Mode(HW, no use mcu) 0 Locked

    245 views
    10 replies
    Latest 4 months ago
    by DONGMIN LIM
<>