TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS280DF810: Can I use a signal conditioning device at a lower data rate than its target application?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Other Parts Discussed in Thread: DS160PR410 , A common question when using a signal conditioning device is can the device support a data rate that is lower than the target data rate. The answer to this is device dependent, but…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Debug procedure if TI TUSB80xx or TUSB40xx hub can not be detected by USB host

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A 1: Check power on reset sequence waveform for 3.3v ,1/1v and GRSTz pin and see if it meets hub power on reset sequence timing 2: Check voltage on USB_VBUS pin and see if the voltage is around 0.5v 3: Check if the crystal is…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TMUXHS4212: When and how to AC coupling the passive MUX?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: TMUXHS4212 When and how do I place the AC coupling capacitors for the passive MUX?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: Does redriver power consumption vary with data rate?

    Evan Su
    Evan Su
    Part Number: DS320PR810 Other Parts Discussed in Thread: DS160PR421 , DS160PR1601 , DS160PR410 , DS160PR810 , DS160PR412 , , DS320PR1601 , DS320PR410 , SN75LVPE5412 , SN75LVPE5421 Applicable to all TI PCIe redrivers for Gen 4: DS160PR410, DS160PR810…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Difference between TUSB804x USB3 hub family

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A Other Parts Discussed in Thread: TUSB8041 , , TUSB8042A , TUSB8043A , TUSB8044A Over the time, TI TUSB804x USB3 hub family has been transitioned from USB3.0 to USB3.1, from TUSB8041 to TUSB8041A/8042A/8043A/8044A. Here is the…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to enable snoop mode with HDMI re-driver/re-timer

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Brief Overview of HDMI PHY: The HDMI physical layer is composed of 4 high-speed lanes, one Display Data Channel (DDC) which operates with I2C signaling, Hot Plug Detect (HPD) for device detection, Consumer Electronic Control …
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS560DF810: Explanation of Crosspoint and Gearbox Modes

    Lucas Wolter
    Lucas Wolter
    Part Number: DS560DF810 Other Parts Discussed in Thread: DS560DF410 , DS560DF810 and DS560DF410 offer a variety of crosspoint and gearbox modes which can be used for 1:2 fanout, channel crossing, and NRZ/PAM4 modulation conversion. In this thread, I will…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR1601: Receiver Detect Reset for x2 SSD Hot Plug Applications

    Nick Peabody
    Nick Peabody
    Part Number: DS320PR1601 Other Parts Discussed in Thread: DS320PR810 In this E2E FAQ, I am going to provide an overview of RX detect with specific information on the RX detect pulse width and frequency, then, I am going to discuss hot plug functionality…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Linear vs. Limited Mode in Redrivers

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 Linear Mode: In linear mode the data received from the GPU’s transmitter is the data that will be sent out of the TX end of the redriver. This means that the GPU’s voltage swing, pre-emphasis…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB216I: How do you create a system with a 10 meter passive cable using a USB2 redriver?

    Ryan Kitto
    Ryan Kitto
    Part Number: TUSB216I Other Parts Discussed in Thread: TUSB217A , TUSB216-Q1 , , TUSB216 , TUSB211A I want to create a system that can support USB2 while utilizing a 10 meter passive cable. Which redriver(s) should I use, and how should they be configured…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    DS100BR111: DS100BR111 SigCon updater profile not working 0 Locked

    107 views
    1 reply
    Latest 9 months ago
    by Drew Miller1
  • Suggested Answer

    TCAN1462-Q1: How about the SOT-23 package of TCAN1462? 0 Locked

    207 views
    1 reply
    Latest 9 months ago
    by Sean Guo
  • Answered

    DP83867IS: Additional items unknown 0 Locked

    184 views
    1 reply
    Latest 9 months ago
    by Vivaan Jaiswal
  • Answered

    DS42MB100: EVK for DS42MB100 available? 0 Locked

    115 views
    1 reply
    Latest 9 months ago
    by Lucas Wolter
  • Answered

    DP83869HM: Ethernet communication issue during transmission and reception 0 Locked

    180 views
    1 reply
    Latest 9 months ago
    by Vivaan Jaiswal
  • Suggested Answer

    DP83869HM: Rx / Tx diff impedance - 100Base-X / 1000Base-X / SGMII 0 Locked

    327 views
    5 replies
    Latest 9 months ago
    by Hillman Lin
  • Suggested Answer

    DS64BR401: baking conditions and requirements 0 Locked

    109 views
    1 reply
    Latest 9 months ago
    by David Waier
  • Suggested Answer

    TPD4E02B04: 3dB@10 GHz Differential Insertion Loss of datasheet 0 Locked

    200 views
    1 reply
    Latest 9 months ago
    by McKenzie Eaker
  • Not Answered

    SN65CML100: Does the SN65CML100 support also DC? 0 Locked

    149 views
    3 replies
    Latest 9 months ago
    by David (ASIC) Liu
  • Answered

    PCA9306: Functionality Question 0 Locked

    289 views
    5 replies
    Latest 9 months ago
    by Tyler Townsend
  • Suggested Answer

    TUSB1002A: USB3.0 0 Locked

    128 views
    1 reply
    Latest 9 months ago
    by Shane Hauser
  • Suggested Answer

    TUSB501-Q1: TUSB501 response time from SuperSpeed receiver plug to enter to redriver 0 Locked

    157 views
    1 reply
    Latest 9 months ago
    by Shane Hauser
  • Suggested Answer

    TIOL111: Current limit of CQ pin for sinking 0 Locked

    205 views
    1 reply
    Latest 9 months ago
    by Jonathan Nerger
  • Answered

    DS90UB947-Q1: Is there any solution to convert eDP to MIPI CSI2? 0 Locked

    354 views
    5 replies
    Latest 9 months ago
    by Jack Scherlag
  • Not Answered

    TCAN1145-Q1: TCAN1145 transceiver INH wake-up pin does not work 0 Locked

    815 views
    11 replies
    Latest 9 months ago
    by Tony Stark
  • Answered

    DS90UB962-Q1: Is ti962/933 support spread setting by device register? 0 Locked

    173 views
    2 replies
    Latest 9 months ago
    by wufeng jiang
  • Not Answered

    DP83TC811EVM: IBIS models 0 Locked

    147 views
    1 reply
    Latest 9 months ago
    by David Creger
  • Answered

    DP83826E: Value of Capacitor Connected to the Center Tap of RJ45 Pulse Transformer 0 Locked

    259 views
    1 reply
    Latest 9 months ago
    by Gerome Cacho
  • Answered

    DS26C31T: Why is "Lead Temperature (TL)" specified at 4 seconds in datasheets? 0 Locked

    181 views
    2 replies
    Latest 9 months ago
    by Shota Mizuno
  • Answered

    ESD321: ESD Circuit 0 Locked

    251 views
    3 replies
    Latest 9 months ago
    by McKenzie Eaker
<>